Is your 1996 Jeep Grand Cherokee Key Fob not working? Don’t worry, programming your key fob for your Jeep Grand Cherokee is a straightforward process you can accomplish right at home. This guide will walk you through the simple steps to program your key fob, ensuring you regain convenient access to your vehicle.
Step-by-Step Guide to Program Your 1996 Jeep Grand Cherokee Key Fob
Programming your 1996 Jeep Grand Cherokee key fob is easier than you might think. Follow these steps carefully to successfully program your remote. Remember, you can program up to four transmitters to your vehicle using this procedure. Make sure to have all the remotes you intend to use ready before you begin.
-
Prepare the Driver’s Side Door: Begin by opening the driver’s side door and leaving it open throughout the entire programming process. This is crucial for initiating the programming sequence.
-
Lock the Driver’s Door Manually: Locate the mechanical door lock lever on the driver’s door. Manually move this lever to the LOCK position. This ensures the system is ready to accept the new key fob programming.
-
Ignition Key to the RUN Position: Insert your ignition key into the ignition switch and turn it to the RUN position. It’s important to note: do not start the engine. Simply turn the key to the position just before starting the car, which is the RUN position.
-
Program the First Key Fob: Aim your first key fob transmitter at the receiver. Press and hold the LOCK (right) button on the remote for 5 seconds. If the programming is successful, you will observe the door locks cycle to the UNLOCK position. This indicates that the receiver has accepted the programming from the key fob.
-
Program Additional Key Fobs (If Applicable): If you have more than one key fob to program for your 1996 Jeep Grand Cherokee, you must program each one in sequence during this same procedure. To program subsequent key fobs, repeat the process: Return the mechanical door lock lever on the driver’s door to the LOCK position. Aim the next transmitter at the receiver and press the LOCK (right) button for 5 seconds. Again, the door locks will cycle to the UNLOCK position to confirm successful programming. Repeat this step for each additional key fob you need to program, up to a maximum of four.
-
Finalizing the Programming: Once you have programmed all desired key fobs, it’s essential to finalize the process. Turn the ignition key OFF, and then turn it back ON within 20 seconds after programming the last transmitter. This step is critical to ensure that only the key fobs programmed during this session will operate the vehicle’s locks.
By following these instructions, you should have successfully programmed your 1996 Jeep Grand Cherokee key fob. Enjoy the convenience of remote access to your vehicle once again!
