Lost your key fob or need to program a new one for your 1997 Jeep Grand Cherokee? Programming your keyless entry remote for your Jeep Grand Cherokee can be done easily at home without a trip to the dealership. This guide provides step-by-step instructions to program your 2-button remote for your 1997 Jeep Grand Cherokee, allowing you to regain keyless entry convenience quickly. You can program up to four transmitters for your vehicle, ensuring every driver has access.
Programming Your 1997 Jeep Grand Cherokee Key Fob
Here are the simple steps to program your 1997 Jeep Grand Cherokee Key Fob:
-
Preparation is Key: Begin by opening the driver’s side door and leaving it open throughout the entire programming process. This is crucial for initiating the programming sequence.
-
Lock the Door Manually: Locate the mechanical door lock lever on the driver’s door. Manually move this lever to the LOCK position. Do not use the power lock button.
-
Ignition to Run (No Start): Insert your ignition key into the ignition switch and turn it to the RUN position. It’s important to turn the key to RUN, which powers the vehicle’s electronics, but do not start the engine.
-
Program the First Remote: Aim your 1997 Jeep Grand Cherokee key fob directly at the receiver. Press and hold the LOCK button (the right button) on the remote for 5 seconds. If the programming is successful, the vehicle’s doors will unlock automatically, indicating the receiver has accepted the new programming.
-
Programming Additional Remotes (Optional): If you have more than one key fob to program for your 1997 Jeep Grand Cherokee, you must program all of them in this sequence. To program subsequent remotes, repeat the following steps immediately:
- Return the mechanical door lock lever on the driver’s door back to the LOCK position.
- Aim the next key fob at the receiver.
- Press and hold the LOCK button on the new remote for 5 seconds.
- Again, the doors should unlock to confirm successful programming.
- Repeat this step for each additional remote you need to program, up to a maximum of four remotes.
-
Finalizing the Programming: Once you have programmed all desired key fobs, it’s essential to finalize the process. Turn the ignition key OFF and then back ON to the RUN position again within 20 seconds of programming the last remote. This step ensures that only the remotes programmed during this session will be recognized by your 1997 Jeep Grand Cherokee’s keyless entry system.
These straightforward steps will help you program your 1997 Jeep Grand Cherokee key fob quickly and efficiently. Enjoy the convenience of your keyless entry system once again!
Source: www.jeepremotes.com
