Lost your key fob or need to program a new one for your 2000 Chevy Impala? Don’t worry, programming your key fob can be a straightforward process you can do right at home. This guide will walk you through the steps to program your 2000 Chevy Impala Key Fob, saving you time and potentially money compared to dealership programming costs.
Step-by-Step Programming Guide for Your 2000 Chevy Impala Key Fob
Before you begin, ensure you have all the key fobs you wish to program for your 2000 Chevy Impala. You can program up to four key fobs using this procedure.
-
Ignition and Radio Setup: Begin by turning your Chevy Impala’s ignition to the “ACC” (Accessory) or “ON” position. It’s crucial not to start the engine. Also, make sure your radio is turned off before proceeding.
-
Enter Settings Mode: Locate the “DISP” button on your radio. Press and hold this button for approximately five seconds. Continue holding until the word “settings” appears on the radio display. This indicates you’ve successfully entered the settings menu.
-
Navigate to FOB PROG: Use the “SEEK” up or down arrow buttons, typically located near the radio tuning controls, to scroll through the settings options. Keep pressing until you see “FOB PROG” displayed on the radio screen. This is the key fob programming option.
-
Access Sub-Menu: Once “FOB PROG” is displayed, press either the “PREV” (Previous) or “NEXT” button to enter the sub-menu. You’ll notice an asterisk next to the currently selected option. “BEGIN” should now be displayed, ready to start the programming sequence.
-
Initiate Programming Sequence: Press the “DISP” button once more to initiate the programming. The display will then flash the message “PUSH FOB”. At this point, take your first key fob transmitter. Simultaneously press and hold both the “LOCK” and “UNLOCK” buttons on the key fob for about 15 seconds. After a short period, you should hear a chime. This chime confirms that the transmitter has been successfully learned by your 2000 Chevy Impala.
-
Program Additional Key Fobs (Optional): If you have more key fobs to program, repeat Step 5 for each additional transmitter. You do not need to press the “DISP” button again. Simply press and hold the “LOCK” and “UNLOCK” buttons on the next key fob you wish to program. Remember, you can program a maximum of four key fobs for your vehicle.
-
Exit Programming Mode: To exit the programming mode once you’ve programmed all your desired key fobs, scroll using the “SEEK” arrows until “EXIT” is displayed on the radio. Press the “DISP” button one last time to exit. You should hear another chime, confirming that you have exited the programming mode.
Congratulations! You have successfully programmed your 2000 Chevy Impala key fob. Test each programmed fob to ensure it correctly locks and unlocks your doors.
Should you require a replacement key fob for your 2000 Chevy Impala or any other vehicle, be sure to visit Keylessentryremotefob.com for a wide selection of key fobs and remotes.
