Lost your 2000 Chevy Impala key fob or need to program a replacement? No need to spend a fortune at the dealership. Programming your key fob for your 2000 Chevy Impala can be done easily at home, saving you both time and money. This step-by-step guide will walk you through the process using your vehicle’s radio system.
Step-by-Step Guide to Program Your 2000 Chevy Impala Key Fob
Follow these instructions carefully to program your 2000 Chevy Impala key fob quickly and efficiently. Make sure you have all your key fobs you wish to program before starting, as you can program up to four remotes in one session.
-
Ignition and Radio Setup: Begin by turning your Chevy Impala’s ignition to the ACC or ON position. Ensure the radio is turned off completely. Do not start the engine.
-
Enter Settings Menu: Locate the “DISP” button on your radio. Press and hold this button for approximately five seconds. Continue holding until the word “settings” appears on the radio display.
-
Navigate to FOB PROG: Use the “SEEK” up or down arrow buttons to scroll through the settings menu. Continue pressing until you see “FOB PROG” displayed on the radio screen.
-
Access Sub Menu: Once “FOB PROG” is displayed, press either the “PREV” or “NEXT” button to enter the sub-menu. You will see an asterisk next to the current selection. “BEGIN” will then appear on the display, indicating you are ready to start programming.
-
Initiate Programming and Transmitter Sync: Press the “DISP” button to begin the programming sequence. The message “PUSH FOB” will flash on the display, prompting you to activate your key fob. On the first key fob you want to program, simultaneously press and hold both the “LOCK” and “UNLOCK” buttons for 15 seconds. You will hear a chime sound, confirming that the transmitter has been successfully learned by your vehicle.
-
Program Additional Transmitters (Optional): If you have additional key fobs to program, repeat Step 5 for each one. You do not need to press the “DISP” button again. Simply press and hold the “LOCK” and “UNLOCK” buttons on the next key fob for 15 seconds. Remember, you can program a maximum of four key fobs to your 2000 Chevy Impala.
Exiting Key Fob Programming Mode
Once you have programmed all your desired key fobs, you need to exit the programming mode to finalize the process.
-
Scroll to EXIT: Use the “SEEK” up or down arrows to scroll through the radio display until you see “EXIT”.
-
Confirm Exit: Press the “DISP” button to select “EXIT” and leave the programming mode. You will hear a chime sound, confirming that you have successfully exited the programming mode.
Congratulations! You have now successfully programmed your 2000 Chevy Impala key fob. Programming your key fob at home is a straightforward process that can save you money and hassle. If you require a replacement key fob for your 2000 Chevy Impala or any other vehicle, visit Keylessentryremotefob.com for a wide selection of key fobs and remotes. Share this helpful guide with your friends and family!
