Is your 2001 Pontiac Grand Am Key Fob no longer working? Or perhaps you’ve purchased a replacement and need to get it programmed to your vehicle? You’re in the right place! This guide will walk you through the process of programming your 2001 Pontiac Grand Am key fob, ensuring you regain convenient remote access to your car.
Before we begin, it’s crucial to understand a few important points. When your Pontiac Grand Am enters programming mode, it clears all previously programmed key fobs. This means you’ll need to program all of your key fobs (up to a maximum of four) during a single programming session. Also, avoid programming near other vehicles that might be in keyless entry programming mode to prevent accidental programming to the wrong car.
There are two methods to program your 2001 Pontiac Grand Am key fob: a tool-free method and a method using a scan tool. Let’s explore both.
Method 1: Tool-Free Key Fob Programming for Your 2001 Pontiac Grand Am
This method is straightforward and doesn’t require any special tools. You can perform this procedure right in your driver’s seat.
Follow these steps carefully:
- Ensure all doors of your 2001 Pontiac Grand Am are fully closed.
- Remove the ignition key from the ignition lock cylinder.
- Press and hold the “unlock” button on the driver’s side door lock switch. Keep holding it throughout the next steps.
- Within 25 seconds of holding the unlock button, insert and remove the ignition key from the ignition cylinder twice. Do not turn the key, simply insert and remove.
- Insert the ignition key a third time and leave it in the ignition lock cylinder. Again, do not turn the key. The ignition must remain in the “LOCK” position for the rest of this procedure.
- Release the “unlock” button on the door lock switch.
- You should hear three chimes. This indicates that your 2001 Pontiac Grand Am has successfully entered key fob programming mode.
- Take your key fob (transmitter). Press and hold both the “lock” and “unlock” buttons simultaneously for about 4 seconds.
- Listen for two chimes. These chimes confirm that the key fob you just programmed has been successfully linked to your vehicle.
- If you have additional key fobs to program, repeat step 8 and 9 for each one, up to a total of four.
- To exit the programming mode, you can either:
- Turn the ignition switch to the “RUN” position.
- Remove the ignition key completely from the ignition switch.
Your 2001 Pontiac Grand Am key fob should now be programmed and ready to use! Test all the buttons to ensure they are functioning correctly.
Method 2: Key Fob Programming with a Scan Tool
This method requires a scan tool and is typically used by automotive professionals or those with access to such equipment.
Here’s how to program your key fob using a scan tool:
- Connect a scan tool to your 2001 Pontiac Grand Am’s diagnostic port.
- Turn the ignition “ON,” but do not start the engine.
- Using your scan tool, navigate to the Body Control Module (BCM) menu.
- Look for and select the “Special Functions” or similar menu option.
- Find and choose the “Program Key Fobs” option within the special functions menu.
- Follow the on-screen instructions provided by your scan tool. These instructions will guide you through the programming process, which usually involves pressing buttons on the key fob when prompted by the scan tool.
- Once the scan tool indicates successful programming, operate the buttons on your key fob to verify that they are working correctly with your 2001 Pontiac Grand Am’s keyless entry system.
Method 2 provides a more guided approach to programming your 2001 Pontiac Grand Am key fob, especially for those familiar with using scan tools for automotive diagnostics and programming.
By following either of these methods, you can easily program your 2001 Pontiac Grand Am key fob and regain the convenience of remote locking and unlocking. If you encounter any difficulties, or prefer professional assistance, it’s always recommended to consult with a qualified automotive technician.
