Is your 2004 Acura TL key fob malfunctioning, or have you acquired a new key fob that needs programming? Fortunately, programming your key fob for the 2004 Acura TL can be done in a few simple steps right at home. This guide will walk you through the process to get your remote working again quickly.
Before you begin, it’s important to understand that this procedure will erase all previously programmed remotes. Therefore, ensure you have all the key fobs you intend to use with your vehicle ready to program at the same time. Also, be sure to complete each step within 4 seconds of the last to stay in programming mode, and program all remotes within 10 seconds of each other.
Here’s how to program your 2004 Acura TL key fob:
-
Turn the Ignition ON: Insert your key into the ignition and turn it to the ON (II) position. This is the position right before you would start the engine.
-
Press Lock or Unlock: Within 4 seconds of turning the ignition ON, press the LOCK or UNLOCK button on the key fob you wish to program. It’s okay to use an unprogrammed remote for this step.
-
Turn the Ignition OFF: Within 4 seconds, turn the ignition switch back to the LOCK (0) position.
-
Turn the Ignition ON Again: Again, within 4 seconds, turn the ignition switch back to the ON (II) position.
-
Repeat Steps 2-4 Twice: Repeat steps 2, 3, and 4 two more times, using the same key fob button as in step 2. You will have cycled the ignition ON and pressed the remote button a total of three times.
-
Press Lock or Unlock (Confirmation): Within 4 seconds of the last ignition cycle, press the LOCK or UNLOCK button on the same key fob. Listen for the power door locks to cycle; this confirms that you have successfully entered programming mode.
-
Program First Remote: Within 10 seconds, press the LOCK or UNLOCK button on the key fob you are currently programming. The door locks should cycle again, confirming successful programming of this remote.
-
Program Additional Remotes: If you have more key fobs to program, within 10 seconds of programming the first, press the LOCK or UNLOCK button on the next key fob. Again, the door locks should cycle to confirm each remote is programmed. Repeat this for all remaining remotes you wish to program.
-
Exit Programming Mode: Turn the ignition switch to the LOCK (0) position to exit programming mode.
-
Test Remotes: Test each programmed key fob to ensure it is working correctly by pressing the LOCK and UNLOCK buttons and verifying the door locks respond.
By following these instructions, you should be able to program your 2004 Acura TL key fob quickly and easily. If you encounter any issues, double-check each step and timing to ensure accuracy. For replacement key fobs and further assistance, visit Keylessentryremotefob.com.
