Is your 2004 GMC Envoy key fob not working like it used to? Or perhaps you’ve acquired a new key fob and need to get it programmed to your vehicle? Luckily, programming a key fob for your 2004 GMC Envoy can often be done right at home without any special tools. This guide provides you with simple, step-by-step instructions to program your 2004 GMC Envoy key fob quickly and efficiently. Follow these directions to get your remote working again and regain convenient access to your vehicle.
Step-by-Step Guide to Programming Your 2004 GMC Envoy Key Fob
Here’s how to program your 2004 GMC Envoy key fob. Make sure to follow each step carefully for successful programming.
-
Ensure all doors are completely closed. This is crucial for the programming sequence to initiate correctly.
-
Insert your key into the ignition cylinder. Do not turn the key yet.
-
Press and HOLD the power UNLOCK button located on the driver’s side door panel. Keep holding this button down throughout the next several steps until step 9 instructs you to release it.
-
Complete steps 5 through 8 in a rapid sequence. Timing is important in this part of the process.
-
Turn the ignition key to the ON position. This is the position just before starting the engine, where the dashboard lights illuminate.
-
Turn the ignition key back to the OFF position.
-
Again, turn the ignition key to the ON position.
-
Turn the ignition key back to the OFF position one more time.
-
Release the power UNLOCK button on the driver’s door panel. At this point, listen for the vehicle to respond. The door locks should automatically cycle, locking and then unlocking. This indicates that your 2004 GMC Envoy has successfully entered programming mode. If the locks do not cycle, you will need to remove the key, open the driver’s side door, and repeat the procedure from step 1.
-
Immediately take your key fob remote. Press and HOLD both the LOCK and UNLOCK buttons simultaneously on the key fob. Continue holding them until you hear the door locks cycle once again. This may take up to 30 seconds. This step programs the key fob to your vehicle.
-
If you have additional key fobs to program, repeat step 10 now for each additional remote, including any previously working remotes. All remotes you want to use must be programmed in this session.
-
Turn the ignition key to the ON position. This action will exit the key fob programming mode.
-
Remove the key from the ignition and test all programmed key fobs to ensure they are working correctly by pressing the LOCK and UNLOCK buttons.
If you encounter any difficulties programming your key fob, or if you prefer to have a professional handle the programming, you can search for a local key fob installer in your area by entering your city or zip code online. Alternatively, if you need a replacement key fob for your 2004 GMC Envoy, or for any other vehicle, visit Keylessentryremotefob.com for a wide selection of key fobs.
