Lost your key fob or need to program a new one for your 2005 Pontiac G6? Dealership key fob programming can be expensive, often costing upwards of $75 just for the service. However, you can actually program a key fob for your 2005 Pontiac G6 yourself, potentially saving a significant amount of money. This guide will walk you through a simple, step-by-step process to program your key fob without any special tools.
Step-by-Step Guide to Program Your 2005 Pontiac G6 Key Fob
This method allows you to program up to four key fobs for your 2005 Pontiac G6. It’s crucial to understand that initiating this programming sequence will erase any previously programmed key fobs. Therefore, you must program all desired key fobs (both old and new) during a single programming session.
Before you begin:
- Ensure you have all the key fobs you wish to program for your 2005 Pontiac G6.
- Sit in the driver’s seat (or the front passenger seat, which some find easier).
- Make sure all doors of your Pontiac G6 are fully closed.
Programming Steps:
-
Remove the ignition key from the ignition lock cylinder of your Pontiac G6.
-
Locate and remove the MALL PGM fuse from your vehicle’s fuse panel. Consult your Pontiac G6 owner’s manual for the precise location of the fuse panel and the MALL PGM fuse.
-
Turn the ignition lock cylinder to the ACC (Accessory) position.
-
Cycle the ignition from ACC to OFF, then back to ACC within one second. Do this quickly.
-
Open and then close any door on your Pontiac G6.
-
Listen carefully for a chime. This chime indicates that the remote control door lock receiver has entered programming mode. If you do not hear a chime, repeat steps 1-5.
Alt: Close-up of a 2005 Pontiac G6 key fob. The image highlights the lock and unlock buttons, essential for the DIY programming procedure.
-
Press and hold both the LOCK and UNLOCK buttons on the first key fob simultaneously for approximately 14 seconds. After about 7 seconds, you may hear a chime confirming synchronization, and after 14 seconds, another chime will confirm successful programming of that fob.
-
Repeat step 7 for each additional key fob you wish to program.
-
Remove the ignition key from the ignition lock cylinder.
-
Reinstall the MALL PGM fuse back into its original location in the fuse panel.
-
Test all programmed key fobs to ensure they are working correctly with your 2005 Pontiac G6’s remote keyless entry system. Verify that the lock and unlock functions are operating as expected.
Troubleshooting:
- If you do not hear the chime in step 6, double-check that you have correctly removed the MALL PGM fuse and followed the ignition and door cycling steps precisely.
- Ensure the battery in your key fob is not depleted.
- If you continue to experience issues, it may be necessary to consult a professional locksmith or your Pontiac dealer.
By following these instructions carefully, you can program your 2005 Pontiac G6 key fob yourself, saving time and money compared to professional services. Enjoy the convenience of your newly programmed remote!
