Is your 2006 Chevy Impala key fob malfunctioning, or did you recently replace it and need to program it? Reprogramming your key fob is often simpler than you might think, and you can do it right at home. This guide provides comprehensive instructions for programming your 2006 Chevy Impala key fob, ensuring you regain seamless remote access to your vehicle.
This guide covers two scenarios, depending on whether your Chevy Impala is equipped with Driver Information Center (DIC) buttons. Refer to your owner’s manual to confirm if your vehicle has DIC buttons. If you need a replacement key fob, you can order one here: 20935330.
Programming Instructions for 2006 Chevy Impala with Driver Information Center (DIC) Buttons
If your 2006 Chevy Impala has Driver Information Center buttons, follow these steps to program your key fob:
-
Turn Ignition to ON: Insert your key into the ignition and turn it to the “ON” position. This position is right before you would crank the engine. Ensure you can access the Driver Information Center display.
-
Access Remote Relearn Mode: Press the “vehicle information” button on the DIC repeatedly until you see the message “PRESS TO RELEARN REMOTE KEY” displayed on the screen.
-
Initiate Learning Mode: Press the “set/reset” button. The Driver Information Center should now display “REMOTE KEY LEARNING ACTIVE,” indicating the vehicle is ready to learn the new key fob.
-
Program the First Key Fob: Take your first key fob remote. Simultaneously press and hold both the “lock” and “unlock” buttons for approximately 15 seconds. You should hear a chime sound, confirming that the key fob has been successfully programmed.
-
Program Additional Key Fobs (Optional): If you have additional key fobs to program, repeat step 4 immediately. The system allows you to program up to eight key fobs for your 2006 Chevy Impala.
-
Exit Programming Mode: Turn the ignition key to the “OFF” position and remove the key from the ignition.
-
Test the Key Fob(s): Test all programmed key fobs to ensure they are working correctly by pressing the lock and unlock buttons.
Programming Instructions for 2006 Chevy Impala without Driver Information Center (DIC) Buttons
If your 2006 Chevy Impala does not have Driver Information Center buttons, use this procedure:
-
Prepare Vehicle: Ensure your vehicle is in “Park” (P) and the ignition key is in the “ON” position. This is the position right before starting the engine.
-
Enter Relearn Mode: Press and release the trip odometer reset stem repeatedly until “RELEARN REMOTE KEY” is displayed in the instrument panel.
-
Activate Learning: Press and hold the trip odometer reset stem for approximately three seconds. The display should change to “REMOTE KEY LEARNING ACTIVE,” indicating the system is in programming mode.
-
Program the First Key Fob: Take your first key fob. Press and hold the “lock” and “unlock” buttons on the key fob simultaneously for about 15 seconds. A chime will sound to confirm successful programming.
-
Program Additional Key Fobs (Optional): To program more key fobs, repeat step 4 immediately. You can program up to eight key fobs with this procedure.
-
Exit Programming Mode and Test: Turn the ignition key to the “OFF” position and remove it. Test each key fob to verify proper programming.
If you encounter any difficulties programming your 2006 Chevy Impala key fob, or prefer professional assistance, you can search for a qualified key fob installer in your area. They can quickly and efficiently program your key fob for you, ensuring everything works perfectly.
