Lost your 2006 Honda key fob or need to program a new replacement? Don’t worry, you might be able to handle this yourself without a trip to the dealership. This guide provides you with a step-by-step process to program your 2006 Honda key fob, getting you back on the road quickly.
Step-by-Step Guide to Program Your 2006 Honda Key Fob
Before you begin, ensure you have all the key fobs you intend to program for your vehicle present. It’s crucial that all doors and the trunk or hatch are fully closed throughout the entire programming procedure. While you only need one working remote to initiate the programming sequence, all remotes must be programmed within the same session. Each step must be executed within 5 seconds of the previous one to ensure successful programming.
-
Get Inside Your Honda: Sit in the driver’s seat of your 2006 Honda with all doors and the trunk/hatch securely closed.
-
Ignition to the ‘ON’ Position & Press ‘Lock’: Insert your key into the ignition and turn it to the ‘ON’ position. This is usually marked as “II” on the ignition bezel, where the dashboard lights illuminate. Within 5 seconds of turning the key to ‘ON’, press the “Lock” button on one of your key fobs for approximately one second, then release.
-
Ignition to the ‘OFF’ Position: Turn the ignition key to the ‘OFF’ position, marked as “I” on the ignition bezel. At this point, the dashboard lights should turn off.
-
Repeat the Cycle Three More Times: Repeat steps 2 and 3 a total of three more times, making it four times in total. Remember, each step must be completed within 5 seconds of the preceding step to maintain the programming sequence.
-
Enter Programming Mode: On the fourth turn of the key to the ‘ON’ position, immediately press the ‘Lock’ button on one of your remotes. If you’ve successfully entered programming mode, you will hear the door locks cycle, making a distinct ‘clunk’ sound. It’s important to note that the doors will not actually lock or unlock at this stage; they will only make the cycling noise to indicate programming mode is active. Do not turn the key off after this step.
-
Program Each Remote: Within 5 seconds of entering programming mode, and then within 5 seconds of programming each subsequent remote, press the ‘Lock’ button on each key fob you are programming for about a second and release. This step must be completed within 10 seconds in total. Each time you press the ‘Lock’ button on a remote, you should hear the door locks cycle again, confirming that the remote’s signal has been recognized and programmed. You can program up to three remotes in total.
-
Exit Programming Mode & Test: Turn the ignition key completely to the ‘OFF’ position and remove the key from the ignition. Open the car door and step out, then close the door. Now, test each of your programmed key fobs to ensure they are working correctly. Press the ‘Lock’ and ‘Unlock’ buttons to verify the door locks are responding. If your key fob has a trunk/hatch release button, you typically need to press and hold this button for a few seconds for the trunk/hatch to open or “pop”.
By following these steps carefully, you should be able to program your 2006 Honda Key Fob Replacement and regain remote access to your vehicle. If you encounter any issues, double-check each step and ensure you are within the time limits specified. If problems persist, consulting a professional locksmith or your local Honda dealership might be necessary.
