Is your 2006 Honda Ridgeline key fob acting up? A common culprit is a dead battery. Before you rush to a dealership or auto shop, you can easily replace the battery yourself. This guide will tell you the correct 2006 Honda Ridgeline Key Fob Battery Size and walk you through the simple replacement process.
Knowing the right battery is the first step. For your 2006 Honda Ridgeline key fob, you’ll need a CR1616 battery. This is a widely available coin cell battery that you can find at most drugstores, electronics stores, and online retailers.
Step-by-Step Guide to Replacing Your 2006 Honda Ridgeline Key Fob Battery
Replacing your key fob battery is a straightforward task that requires minimal tools and time. Here’s how to do it:
Tools You’ll Need
- A small Phillips head screwdriver
- A small flathead screwdriver or similar thin tool
- A new CR1616 battery
Opening the Key Fob
-
Locate the Screw: On the back of your key fob, you’ll find a small Phillips head screw. Use your Phillips head screwdriver to carefully remove this screw.
-
Separate the Clamshell: Once the screw is removed, you’ll need to gently separate the two halves of the key fob. There’s often a small edge or seam where you can start to pry it open. A flathead screwdriver can be helpful here, but be careful not to scratch the plastic. Start at the keyring end and gently work your way around the seam, nudging the two halves apart.
Identifying the Battery
Once you have the key fob open, you’ll see the internal components. The battery is usually easily visible and held in place by small clips.
Battery Replacement
-
Remove the Old Battery: Note the orientation of the old battery before removing it. Typically, the positive (+) side faces up. You can use a small flathead screwdriver to gently pry the old battery out of its holder.
-
Insert the New Battery: Take your new CR1616 battery and insert it into the battery compartment. Ensure you place it with the correct orientation – the wide side (positive side) usually faces down into the fob. Double-check the markings inside the battery compartment if you are unsure.
Closing the Key Fob
Carefully align the two halves of the key fob and press them back together until they snap closed. Replace the Phillips head screw and tighten it gently.
Testing Your Key Fob
Test all the buttons on your key fob to ensure they are working correctly. If everything works as expected, you’ve successfully replaced your 2006 Honda Ridgeline key fob battery!
Common Mistakes to Avoid
One common mistake when replacing a key fob battery is inserting the new battery with the wrong polarity. Even if you are sure you have it right, double-check the orientation before closing the key fob. Inserting the battery upside down will prevent the key fob from working and can lead to unnecessary frustration. If your key fob doesn’t work after replacing the battery, the first thing to check is the battery orientation.
Replacing your 2006 Honda Ridgeline key fob battery is a simple DIY task that can save you time and money. By knowing the correct 2006 Honda Ridgeline key fob battery size (CR1616) and following these steps, you can quickly get your key fob working again.
