Lost your 2006 Pontiac G6 Key Fob or need to program a new one? Instead of heading straight to a dealership and paying a hefty price, you can actually program a new key fob for your 2006 Pontiac G6 right at home. This guide will walk you through the steps to program your key fob, saving you time and money. It’s a straightforward process that many Pontiac G6 owners have successfully completed themselves.
Step-by-Step Guide to Programming Your 2006 Pontiac G6 Key Fob
Programming your 2006 Pontiac G6 key fob requires no special tools and can be done in a few simple steps. Just follow these instructions carefully:
Preparation Before You Begin
- Get in Your Pontiac G6: Sit comfortably in the driver’s seat. For easier access to the fuse panel, some find the front passenger seat more convenient.
- Remove the Key: Make sure the ignition key is removed from the ignition lock cylinder.
- Close All Doors: Ensure all doors of your Pontiac G6 are completely closed.
- Locate and Remove the MALL PGM Fuse: Find the fuse panel in your Pontiac G6. Consult your owner’s manual if you’re unsure of its location. Once located, remove the MALL PGM fuse. This fuse is crucial for initiating the programming sequence.
Programming Sequence
- Turn Ignition to ACC Position: Turn the ignition lock cylinder to the ACC (Accessory) position.
- Cycle Ignition ACC and OFF: Turn the ignition OFF, and then quickly back to the ACC position within one second.
- Open and Close Door: Open and then close any vehicle door. This action signals the system to enter programming mode.
- Listen for the Chime: You should hear a chime sound. This chime indicates that the remote control door lock receiver has successfully entered the programming/diagnostic mode. If you don’t hear a chime, repeat steps 1 through 7 again.
- Program the Transmitter: Press and hold both the LOCK and UNLOCK buttons on the key fob you want to program simultaneously for approximately 14 seconds.
- Repeat for Additional Fobs: If you have additional key fobs to program, repeat step 9 for each one. Remember, you need to program all your key fobs (both old and new) during this session as programming a new fob will erase previous programming. Up to 4 transmitters can be programmed.
- Remove Key from Ignition: Take the ignition key out of the ignition lock cylinder.
- Reinstall the MALL PGM Fuse: Put the MALL PGM fuse back into its original location in the fuse panel.
Final Steps and Verification
- Test Your Key Fobs: Verify that all programmed key fobs are working correctly by testing the LOCK and UNLOCK buttons.
Conclusion
Congratulations! You’ve successfully programmed your 2006 Pontiac G6 key fob yourself. By following these simple steps, you’ve avoided the expense of dealership programming and regained full control over your vehicle’s keyless entry system. This DIY method is a great way to save money and take a little control back when it comes to car maintenance.
