Is your 2006 Toyota Highlander key fob no longer working, or did you recently purchase a replacement key fob remote? Programming your key fob yourself can save you time and money compared to visiting a dealership. This simple, step-by-step guide will walk you through the process of programming your 2006 Toyota Highlander key fob quickly and easily at home. Follow these instructions carefully to regain remote access to your vehicle.
Step-by-Step Programming Instructions
These instructions are designed for the 2006 Toyota Highlander and should enable you to program your key fob remote successfully. Ensure you follow each step precisely for optimal results.
-
Start with Key and Doors: Begin by removing the key from the ignition. Make sure the driver’s side door is open and unlocked. Crucially, all other doors, including the trunk or liftgate, must be completely closed.
-
Key Insertion Sequence (Part 1): Within a tight 5-second window, insert your key into the ignition switch and then immediately pull it out. Repeat this insert and pull-out action a second time.
-
Door Cycling (Part 1): Next, you need to cycle the driver’s side door. Close the driver’s side door and then open it again. Repeat this close and open cycle of the driver’s door a second time.
-
Key Insertion Sequence (Part 2): Insert the key into the ignition switch one more time and then remove it.
-
Door Cycling (Part 2): Again, cycle the driver’s side door by closing it and then opening it. Repeat this close and open cycle of the driver’s door for a second time.
-
Final Key Insertion: Insert the key into the ignition switch and this time, leave it in the ignition. Do not remove it.
-
Close Driver’s Door: Close the driver’s side door.
-
Ignition Cycle: Turn the ignition switch to the “ON” position, and then immediately turn it back to the “OFF” position. Do not start the engine.
-
Remove Key: Take the key out of the ignition switch.
-
Confirmation – Locks Will Cycle: At this point, you should observe the door locks cycling. This automatic locking and unlocking sequence indicates that your 2006 Toyota Highlander has successfully entered programming mode and is ready to learn the new key fob remote.
-
Programming the Key Fob: Take the first key fob remote you wish to program. Press and hold both the “LOCK” and “UNLOCK” buttons simultaneously for approximately 1.5 seconds. After releasing these buttons, immediately press and hold only the “LOCK” button for about 2 seconds.
-
Confirmation – Locks Cycle Again: The door locks will cycle once more. This lock cycle confirms that the remote has been successfully programmed. If you have additional key fobs to program, repeat step 12 for each additional remote. If you are finished programming remotes, proceed to the next step.
-
Complete Programming: Open the driver’s side door. This action signals the system that you have finished programming. Programming for your 2006 Toyota Highlander key fob is now complete. Test your newly programmed key fob to ensure it is working correctly by locking and unlocking your doors remotely.
Need a Replacement Key Fob?
If you need to purchase a replacement key fob for your 2006 Toyota Highlander, or for any other vehicle, visit Keylessentryremotefob.com for a wide selection of key fobs and remotes. You can find the correct Key Fob for your vehicle and ensure seamless remote access.
If you experience any difficulties programming your key fob, consider consulting a professional automotive locksmith or key fob programming service in your area. They have the expertise and tools to assist you.
