Is your 2007 Acura MDX key fob malfunctioning, or did you recently purchase a replacement? Programming your key fob yourself is a straightforward process that can save you time and money compared to visiting a dealership. This guide provides easy-to-follow instructions to program your 2007 Acura MDX key fob, ensuring you regain full access and control of your vehicle’s keyless entry system.
Before you begin, it’s crucial to understand that the programming sequence will erase all previously programmed remotes. Therefore, ensure you have all key fobs you intend to use with your 2007 Acura MDX, including any existing ones, present during the programming process. You can program up to three remotes for your vehicle at one time.
Here are the steps to program your 2007 Acura MDX key fob:
-
Turn the Ignition ON: Insert your key into the ignition and turn it to the “ON” position. This is the position right before you would start the engine.
-
Press Lock or Unlock Quickly: Within 4 seconds of switching the ignition ON, press the “LOCK” or “UNLOCK” button on the first remote you want to program.
-
Turn the Ignition OFF: Within 4 seconds after pressing the button on the remote, switch the ignition back to the “OFF” position.
-
Turn the Ignition ON Again: Again, within 4 seconds of turning the ignition OFF, switch it back to the “ON” position.
-
Repeat Steps 2-4 Twice: Repeat the sequence of pressing the “LOCK” or “UNLOCK” button within 4 seconds of turning the ignition “ON,” followed by turning the ignition “OFF” within 4 seconds, and then back “ON” within 4 seconds, two more times. In total, you will perform steps 2-4 three times.
-
Press Lock or Unlock (Final Time for Programming Mode): Within 4 seconds after the last ignition cycle (turning “ON” for the third time), press the “LOCK” or “UNLOCK” button on the first remote one more time.
-
Confirmation – Doors Lock and Unlock: If you have successfully entered programming mode, the doors will automatically lock and then unlock. This confirms that your 2007 Acura MDX is now ready to learn the remote signals.
-
Program Remotes: Within 10 seconds of the doors locking and unlocking, press the “LOCK” or “UNLOCK” button on the first remote. The doors should lock and unlock once to confirm that this remote is programmed. Repeat this step for each additional remote you want to program. For each successful programming, the doors will lock and unlock.
-
Turn Ignition OFF (Exit Programming): Once you have programmed all desired key fobs, turn the ignition to the “OFF” position to exit the programming mode.
Important Reminders:
- All Remotes Required: Remember, you must program all of your remotes, both new and old, during this process. The system memory is overwritten when you start programming.
- Timing is Key: The timing in these steps is crucial. Make sure to perform each step within the specified 4 or 10-second window.
- Confirmation: The door lock/unlock confirmation is essential to ensure you are proceeding correctly.
By following these instructions carefully, you should be able to successfully program your 2007 Acura MDX key fob. If you need to purchase a replacement key fob for your Acura MDX or other vehicles, visit Keylessentryremotefob.com for a wide selection and great deals.
