Lost your key fob or need to program a new one for your 2007 Chevy Tahoe LTZ? Don’t worry, programming your key fob is a straightforward process you can often do yourself right at home. This guide provides step-by-step instructions for programming your 2007 Chevrolet Tahoe keyless entry remote. The procedure varies slightly depending on whether your vehicle is equipped with Driver Information Center (DIC) buttons. Follow the instructions below that apply to your Tahoe.
Programming Your 2007 Chevy Tahoe LTZ Key Fob with Driver Information Center (DIC) Buttons
If your Chevy Tahoe LTZ has Driver Information Center buttons on the steering wheel, use this method to program your key fob:
-
Turn the Ignition ON: Insert your key into the ignition and turn it to the “ON” position. This is the position right before you start the engine. Ensure you can access the Driver Information Center display.
-
Access Remote Relearn Mode: Press the vehicle information button ( INFO ) repeatedly until the display shows PRESS TO RELEARN REMOTE KEY.
-
Activate Learning Mode: Press the set/reset button ( SET/RESET ) until the display changes to REMOTE KEY LEARNING ACTIVE. The vehicle is now in programming mode.
-
Program the First Remote: Take your first key fob and simultaneously press and hold the lock and unlock buttons for approximately 15 seconds. You should hear a chime sound, indicating that the remote has been successfully programmed.
-
Program Additional Remotes (Optional): If you have additional key fobs to program, repeat step 4 immediately. The 2007 Chevy Tahoe can accommodate up to eight key fobs.
-
Exit Programming Mode: Turn the ignition key to the “OFF” position and remove the key from the ignition.
-
Test Your Remotes: Test all programmed key fobs to ensure they are working correctly by locking and unlocking the doors, and activating other remote functions.
Programming Your 2007 Chevy Tahoe LTZ Key Fob without Driver Information Center (DIC) Buttons
If your 2007 Chevy Tahoe LTZ does not have Driver Information Center buttons, use this procedure. Make sure your vehicle is in Park (P) and the key is in the “ON” position (as far as it will go without starting the engine).
-
Access Relearn Mode: Press and hold the trip odometer reset stem located on the instrument panel until the display shows RELEARN REMOTE KEY.
-
Activate Learning Mode: Continue to press and hold the trip odometer reset stem for about three seconds. The message REMOTE KEY LEARNING ACTIVE will appear, indicating the system is ready to program remotes.
-
Program the First Remote: On your first key fob, press and hold both the lock and unlock buttons simultaneously for approximately 15 seconds. A chime will sound to confirm successful programming.
-
Program Additional Remotes (Optional): To program more key fobs, repeat step 3 immediately. You can program up to eight remotes for your 2007 Chevy Tahoe.
-
Exit Programming Mode and Test: Turn the ignition key to the “OFF” position and remove it. Test all programmed remotes to verify they are functioning properly.
By following these simple steps, you can easily program your 2007 Chevy Tahoe Ltz Key Fob and regain full keyless entry functionality.
