Is your 2007 Honda Ridgeline key fob not working as reliably as it used to? Before you assume the worst or head to a dealership, you might just need a new battery. Replacing the battery in your key fob is a simple task you can easily do yourself, saving time and money. This guide will walk you through each step to replace your 2007 Honda Ridgeline Key Fob Battery, ensuring you avoid common pitfalls and get your key fob working like new again.
The process is straightforward and similar to other Honda models of the era. You’ll be surprised how quickly you can complete this task with just a few basic tools and a little patience. Don’t be intimidated – let’s get started and bring your key fob back to life!
To begin, you’ll need to gather a few items:
- A small Phillips head screwdriver
- A small flat head screwdriver (or similar prying tool)
- A new CR1616 battery
Once you have your tools and replacement battery, follow these simple steps to replace your 2007 Honda Ridgeline key fob battery:
Step 1: Open the Key Fob
Locate the small Phillips head screw on the back of your key fob. Using your Phillips head screwdriver, carefully remove this screw and set it aside in a safe place. This screw holds the two halves of the key fob casing together.
After removing the screw, you’ll need to gently separate the two halves of the key fob. The key fob is a clamshell design, and after removing the screw, it is held together by small clips. Start at the keyring end of the fob, where there is often a small protruding edge. Use your flat head screwdriver or your fingernail to gently pry apart the two halves. Work your way around the seam, gently nudging and prying until the case begins to separate. Avoid using excessive force, as you could damage the plastic casing.
Step 2: Access the Battery Compartment
Once the clamshell casing is open, you will see the internal components of your 2007 Honda Ridgeline key fob. The internal unit itself is often composed of two parts that clip together. Carefully examine the internal unit and locate the seam where these two parts connect.
Using your small flat head screwdriver, gently pry apart these two internal pieces. They should separate relatively easily. Once open, you will see the battery compartment and the CR1616 battery.
Step 3: Replace the Battery
Take note of the orientation of the old battery before removing it. Specifically, observe which side is facing up (usually the positive side with markings). This is crucial to ensure the new battery is installed correctly. Use the flat head screwdriver to carefully pry out the old CR1616 battery.
Now, take your new CR1616 battery and install it in the same orientation as the old battery. The wide side of the battery, which is typically the positive (+) side, should be facing down into the compartment. Ensure the battery is securely seated in its place.
Step 4: Reassemble the Key Fob
With the new battery correctly installed, carefully snap the two halves of the internal unit back together. You should hear a click as they securely connect. Next, align the two halves of the key fob clamshell casing and press them firmly together until they snap closed. Finally, reinsert and tighten the small Phillips head screw you removed earlier.
That’s it! You have successfully replaced the battery in your 2007 Honda Ridgeline key fob. Test your key fob to ensure it is now working correctly, locking and unlocking your doors and starting your vehicle remotely if equipped.
By following these steps, you can confidently replace your 2007 Honda Ridgeline key fob battery and avoid the unnecessary expense of dealership service. Remember to always double-check the battery orientation to prevent any issues. Enjoy the renewed reliability of your key fob!
