Lost your key fob or need to program a new one for your 2009 Pontiac G6? Instead of heading straight to a dealership and paying hefty fees, you can actually program your key fob yourself at home. This guide provides you with straightforward, step-by-step instructions to program your 2009 Pontiac G6 key fob, saving you time and money.
This method is designed for adding or reprogramming key fobs when you already have at least one working key and are simply adding new fobs or re-syncing existing ones. It’s a relatively simple process that you can complete in just a few minutes, right in your car. Let’s get started and get your key fob programmed quickly and efficiently.
Step-by-Step Programming Instructions for Your 2009 Pontiac G6 Key Fob
Follow these detailed steps to program your key fob for your 2009 Pontiac G6:
-
Get Comfortable in the Driver’s Seat: Sit in the driver’s seat of your Pontiac G6. While the original instructions mention the driver’s seat, some users find it slightly easier to perform these steps from the front passenger seat due to fuse panel access, but the driver’s seat is perfectly acceptable.
-
Remove the Key from the Ignition: Ensure the ignition key is removed from the ignition lock cylinder.
-
Close All Doors: Make sure all doors of your Pontiac G6 are fully closed. This is crucial for the system to enter programming mode correctly.
-
Locate and Remove the MALL PGM Fuse: Find the fuse panel in your Pontiac G6. Refer to your vehicle’s owner’s manual if you are unsure of the fuse panel’s location. Once located, find the fuse labeled “MALL PGM” (Mall Program) and carefully remove it. This fuse is related to the Remote Control Door Lock Receiver.
-
Turn the Ignition to ACC Position: Insert your key into the ignition lock cylinder and turn it to the “ACC” (Accessory) position. This position is usually one click before the “ON” position and powers on some of the car’s accessories.
-
Cycle Ignition ACC to OFF to ACC Quickly: Turn the ignition lock cylinder from the “ACC” position to the “OFF” position, and then immediately back to the “ACC” position again, all within one second. This quick cycling is important for initiating the programming sequence.
-
Open and Close Any Vehicle Door: Open and then close any door on your Pontiac G6. This action signals to the system that you are ready to enter programming mode.
-
Listen for the Chime: After closing the door, listen carefully for a chime. This chime indicates that the remote control door lock receiver has successfully entered the programming/diagnostic mode. If you do not hear a chime, you will need to repeat the process from step 1 to ensure each step is followed correctly.
-
Program the Transmitter (Key Fob): Take the key fob you wish to program. Press and hold both the “LOCK” and “UNLOCK” buttons on the key fob simultaneously for approximately 14 seconds.
-
Repeat for Additional Transmitters: If you have additional key fobs to program, repeat step 9 for each additional transmitter. Remember that once you enter programming mode, all previously programmed transmitters are erased. Therefore, you must program all desired transmitters (both old and new) during this session, up to a maximum of 4 transmitters.
-
Remove Key and Reinstall Fuse: Remove the ignition key from the ignition lock cylinder. Go back to the fuse panel and reinstall the “MALL PGM” fuse that you removed in step 4.
-
Test the Key Fobs: Thoroughly test all programmed key fobs to ensure they are operating correctly. Check the lock, unlock, and any other functions your key fob may have to confirm successful programming.
By following these steps, you should be able to successfully program your 2009 Pontiac G6 key fob. This DIY method allows you to manage your key fobs conveniently and avoid unnecessary expenses. Remember to always double-check each step to ensure proper execution and a successful outcome.
