Lost your 2010 Gmc Acadia Key Fob or need to program a new replacement? Programming your key fob for your 2010 GMC Acadia can often be done in the comfort of your own driveway. This guide provides straightforward instructions to help you get your key fob working quickly. Whether your Acadia is equipped with a driver information center (DIC) or not, we’ve got you covered with clear procedures.
Procedure #1: For Acadia Models with Driver Information Center (DIC)
If your 2010 GMC Acadia has a driver information center, indicated by buttons on the steering wheel with an “i” symbol, use these steps:
-
Ignition Start: Insert your key into the ignition. Turn the key to the “on” position. It’s crucial not to start the engine, just turn the ignition to the point where the car’s electronics are active.
-
Access Relearn Remote Key Menu: Locate the “Information” button on your steering wheel. Press this button repeatedly until you see “Relearn Remote Key” displayed on the driver information screen.
-
Initiate Learning Mode: Once “Relearn Remote Key” is displayed, press the “set/reset” button. This button typically has a checkmark symbol. Press it until the display changes to “Remote Key Learning Active”. The vehicle is now in programming mode, ready to learn your key fob signal.
-
Program Key Fob: Take your 2010 GMC Acadia key fob and simultaneously press and hold both the “Lock” and “Unlock” buttons. Continue holding them until the vehicle emits two chimes. These chimes are your confirmation that the key fob has been successfully programmed. If you have additional key fobs (new or existing) that you want to use with your Acadia, repeat this step 4 immediately for each fob. It’s important to program all fobs at this stage to ensure they all function correctly.
-
Exit Programming Mode: Turn the ignition key back to the “off” position. This action will exit the key fob programming mode. Test all programmed key fobs to ensure they are working correctly by locking and unlocking your GMC Acadia remotely.
Procedure #2: For Acadia Models Without Driver Information Center
If your 2010 GMC Acadia model does not have the driver information center buttons on the steering wheel, follow these instructions:
-
Ignition On: Insert the key into the ignition and turn it to the “On” position, ensuring you do not start the engine.
-
Access Relearn Remote Key: Locate the trip odometer reset button, usually found on the instrument panel near the speedometer. Press and release this button repeatedly until “Relearn Remote Key” appears in the display.
-
Activate Learning Mode: Press and hold the trip odometer reset button. Keep holding it until “Remote Key Learning Active” is displayed. The vehicle is now ready to learn the signal from your key fob.
-
Program Key Fob: Take your 2010 GMC Acadia key fob. Press and hold both the “Lock” and “Unlock” buttons simultaneously. Hold these buttons until the vehicle chimes twice, indicating successful programming. If you have more key fobs to program, repeat step 4 immediately for each one, including any previously working fobs. All key fobs intended for use with the vehicle must be programmed in this session.
-
Finish Programming: Turn the ignition key to the “off” position to exit the programming sequence. Test each key fob to verify it correctly locks and unlocks your 2010 GMC Acadia.
Important Note: It’s critical to program all of your key fobs (both new and existing) during the same programming session. If you only program a new key fob, any previously programmed fobs will no longer work. This is a common issue, so always remember to reprogram all remotes you intend to use.
Should you encounter any difficulties programming your 2010 GMC Acadia key fob, or prefer professional assistance, you can search online for local key fob programming services in your area. However, for many owners, these steps will provide a successful and cost-effective DIY solution.
