2011 Ford Flex Key Fob Programming: A Simple Guide

Are you looking to program a spare key fob for your 2011 Ford Flex? It’s a smart move to have a backup, and fortunately, if you already have two working keys, you can program a new one yourself. This guide will walk you through the steps to program a spare intelligent access key for your 2011 Ford Flex, saving you a trip to the dealership.

Step-by-Step Programming Instructions

Before you begin, there are a few crucial things to remember. This procedure is specifically for programming a spare intelligent access key.

Before You Begin

  • Maximum Keys: Your 2011 Ford Flex can only have a maximum of four programmed intelligent access keys.
  • Two Existing Keys Required: To perform this DIY programming, you must have two previously programmed intelligent access keys already working with your vehicle. If you don’t have two working keys, you’ll need to visit an authorized Ford dealer for programming.
  • Vehicle Off and Doors Closed: Ensure your Ford Flex is completely turned off and all doors are fully closed before starting the process. Keep the doors closed throughout the entire procedure.
  • Timing is Key: You need to perform each step within 30 seconds of the previous one. If you exceed this time, or perform any steps out of order, you’ll need to wait at least one minute before trying again.
  • Read First, Act Second: Carefully read and understand all the steps before you start the programming sequence.

Programming Steps

  1. Locate the Backup Slot: Place the new, unprogrammed intelligent access key into the backup slot located inside your center console. Make sure the key ring end is facing the rear of the vehicle and the buttons are facing towards the passenger side.

  2. Unlock Three Times: Press the power door unlock control switch (either on the driver’s or passenger’s side door) three times.

  3. Brake Pedal Once: Press and release the brake pedal one time.

  4. Lock Three Times: Press the power door lock control switch (driver or passenger side) three times.

  5. Brake Pedal Again: Press and release the brake pedal one time.

    At this point, the indicator light on your START/STOP button should start flashing rapidly. This indicates that your Ford Flex has entered programming mode and has recognized the presence of two programmed intelligent access keys inside the vehicle.

  6. Press START/STOP Button: Within one minute of the indicator light flashing, press the START/STOP button. A message should appear in the information display on your dashboard confirming that the new intelligent access key has been successfully programmed.

  7. Remove and Test: Take the newly programmed intelligent access key out of the center console slot. Press the unlock button on the new key fob to exit the programming mode.

  8. Verify Functionality: Test the remote entry functions of your new key fob. Press the lock button, then the unlock button (ensure you end with unlock). Finally, start your 2011 Ford Flex using the new intelligent access key to confirm that it works correctly.

Troubleshooting

If you encounter issues during the programming process, double-check that you have followed all steps exactly as outlined and within the time limits. If the programming is unsuccessful, it’s likely that you may not have two previously programmed keys, or there may be another issue. In such cases, it’s recommended to visit your authorized Ford dealer for assistance with key fob programming.

By following these steps carefully, you can easily program a spare key fob for your 2011 Ford Flex and gain the peace of mind that comes with having a backup key.

Comments

No comments yet. Why don’t you start the discussion?

Leave a Reply

Your email address will not be published. Required fields are marked *