Lost or need to replace your 2011 Mitsubishi Galant Key Fob? The good news is you might be able to program a new key fob yourself, saving time and money. This guide provides straightforward instructions for programming both the key and remote functions of your 2011 Mitsubishi Galant key fob. Follow these steps to get your new key working with your vehicle.
Programming the Key Portion of Your 2011 Mitsubishi Galant Key Fob
Before you begin, ensure that the key portion of your new 2011 Mitsubishi Galant key fob has been properly cut by a locksmith. This step is crucial as the key must physically match your vehicle’s ignition cylinder. Once you have a correctly cut key, proceed with the programming steps below:
- Insert and Turn First Working Key: Place your existing, working key into the ignition cylinder.
- Ignition ON for 5 Seconds: Turn the ignition to the ON position (do not start the engine). Hold it in the ON position for 5 seconds, then turn it back to the OFF position and remove the key.
- Insert Second Working Key: Within 10 seconds of removing the first key, insert a second working key into the ignition and turn it to the ON position. You should observe the security light flashing twice. Turn the ignition back to OFF and remove the second key.
- Insert New Key: Within 10 seconds, insert the new, unprogrammed 2011 Mitsubishi Galant key into the ignition and turn it to the ON position.
- Wait for Security Light: The security light should illuminate for approximately 3 seconds. This indicates that your new key has been successfully programmed to start your 2011 Mitsubishi Galant.
- Program Additional Keys (Optional): If you have more keys to program, immediately repeat steps 4 and 5. Remember that all new keys must be programmed within 30 seconds of the security light flashing twice in step 3.
- Exit Programming Mode: To exit the key programming mode, simply leave the ignition switch in the ON position for more than 30 seconds.
Programming the Remote Portion of Your 2011 Mitsubishi Galant Key Fob
After successfully programming the key portion, you can now program the remote functionality of your 2011 Mitsubishi Galant key fob. This process involves using the OBD-II data port in your vehicle.
-
Locate the OBD-II Data Port: The OBD-II Data Port in your 2011 Mitsubishi Galant is typically located underneath the driver’s side dashboard, usually to the right of the steering column.
-
Insert Key and Set to OFF: Insert your key into the ignition cylinder and ensure it is in the OFF position.
-
Prepare Jumper Wire: Locate terminals 1 and 4 in your OBD-II Data Port. Using a suitable jumper wire, prepare to connect these two terminals. Ensure that there are metal contact pins present in both terminals 1 and 4.
-
Connect Terminals 1 and 4 & Hazard Switch: Within 10 seconds of connecting the jumper wire between terminals 1 and 4, press the Hazard Switch 6 times. If done correctly, the doors will automatically lock and unlock once, indicating that your system has entered programming mode. Keep the jumper wire connected throughout the programming process.
-
Press LOCK Button on Remote: Press the LOCK button on the 2011 Mitsubishi Galant key fob you wish to program three times within 10 seconds. Upon successful programming of the remote, the doors will lock and unlock once again.
-
Program Additional Remotes (Optional): Repeat step 5 for any additional remotes you need to program, including existing remotes. You can program up to 4 remotes within one minute. Each successful remote programming will be indicated by the doors locking and unlocking once.
-
Disconnect and Exit: Disconnect the programming jumper wire from the OBD-II Data Port and remove the key from the ignition.
By following these instructions, you should be able to program your 2011 Mitsubishi Galant key fob for both key and remote functions. If you encounter any difficulties, it is recommended to consult a professional locksmith or your Mitsubishi dealership for assistance.
