Experiencing a “key fob not detected” message in your 2012 Cadillac SRX can be frustrating. Before assuming a costly malfunction, you might just need to reprogram your key fob. Luckily, Cadillac SRX models are designed with a user-friendly system allowing you to program new or existing key fobs directly, without needing a locksmith or dealership for simple programming procedures. This guide will walk you through the steps to program your 2012 Cadillac SRX key fob, whether you have a working remote or are starting from scratch.
Programming a 2012 Cadillac SRX Key Fob When You Have a Working Remote
If you currently have one functioning key fob and wish to add another, follow these straightforward steps:
- Ensure your Cadillac SRX is completely turned off.
- Place the working remote in the designated cupholder. Keep the new remote you intend to program with you.
- Locate the key lock cylinder on the exterior driver’s side door. Insert your key into this lock.
- Within ten seconds, turn the key to the unlock position five times.
- Observe the Driver Information Center (DIC) display. It should show “Ready to Learn Electronic key #2, 3, 4 ETC.” indicating the system is in programming mode.
- Access the transmitter pocket. This is located inside the center console between the driver and front passenger seats. Open the storage compartment and lift up the storage tray to reveal the transmitter pocket.
- Place the new remote into the transmitter pocket, ensuring the buttons are facing the front of the vehicle.
- Press the ignition button. Once the remote is successfully learned, the DIC display will update to show it’s ready for the next remote programming.
- Remove the programmed remote from the transmitter pocket and press the unlock button on the remote to confirm.
- To program any additional remotes, repeat steps 6 through 9.
- Once you have programmed all desired remotes, press and hold the ignition button for ten seconds to exit the programming mode.
Programming a 2012 Cadillac SRX Key Fob When You Have No Working Remotes
If you’ve lost all your key fobs or none are functioning, you can still program a new one. This process takes a bit longer due to a security delay:
- Ensure your Cadillac SRX is turned off.
- Insert the key into the key lock cylinder on the driver’s door.
- Turn the key to the unlock position five times within ten seconds.
- The Driver Information Center (DIC) will display “REMOTE LEARN PENDING, PLEASE WAIT.”
- Wait for ten minutes until the DIC display changes to “PRESS ENGINE START BUTTON TO LEARN,” then press the ignition button. The DIC will again show “REMOTE LEARN PENDING, PLEASE WAIT.”
- Repeat step 5 two more times. After the third cycle, all previously programmed remotes will be erased from the system’s memory. This is a necessary step to start fresh. The DIC display should now indicate “READY FOR REMOTE #1.”
- Place the new remote into the transmitter pocket, located in the center console as described earlier, with the buttons facing the front.
- Press the ignition button. When the remote is learned, the DIC will show it is ready for the next remote.
- Remove the remote from the transmitter pocket and press unlock on the remote.
- To program additional remotes, repeat steps 7 through 9.
- After programming all remotes, press and hold the ignition button for ten seconds to exit programming mode.
By following these steps, you should be able to resolve a “2012 Cadillac Srx Key Fob Not Detected” issue by successfully programming your key fob yourself. If you continue to experience issues, it’s recommended to consult with a certified automotive technician to diagnose potential underlying problems with your vehicle’s remote keyless entry system.
