Is your 2015 Jeep Cherokee key fob acting up? A dead or dying key fob battery is a common culprit, and thankfully, it’s an easy fix you can handle yourself. No need to rush to the dealership right away! This guide will walk you through a straightforward 2015 Jeep Cherokee Key Fob Battery Replacement.
Why Replace Your Key Fob Battery?
Like any battery, your Jeep Cherokee key fob battery weakens over time. You might notice your remote start isn’t working from as far away, or perhaps you need to be closer to your vehicle for the doors to unlock. In some cases, like the one described in a recent forum post by a Jeep Cherokee owner, new key fobs can even intermittently fail to start the vehicle, mimicking a dead battery issue even when the car battery is fine. While their issue was more complex, starting with a fresh key fob battery is always a good first step in diagnosing key fob problems.
What You’ll Need:
- A new CR2032 battery. This is the standard battery for most Jeep Cherokee key fobs.
- A small flathead screwdriver or a similar tool to open the key fob case.
- Your 2015 Jeep Cherokee key fob.
Step-by-Step Battery Replacement:
-
Locate the Notch: On the back of your Jeep Cherokee key fob, you’ll find a small notch. This is where you’ll insert your flathead screwdriver.
-
Gently Pry Open the Case: Carefully insert the flathead screwdriver into the notch and gently twist. This should begin to separate the two halves of the key fob case. Work your way around the seam, gently prying until the case is open. Avoid forcing it, as you could damage the plastic.
-
Remove the Old Battery: Once the case is open, you’ll see the CR2032 battery. Take note of which way the positive (+) side is facing. You can usually use your fingertip or the edge of the screwdriver to gently pop the old battery out.
-
Insert the New Battery: Place the new CR2032 battery into the compartment, making sure the positive (+) side is facing the same direction as the old battery was. It should snap into place easily.
-
Close the Key Fob Case: Carefully snap the two halves of the key fob case back together. Ensure they are firmly closed and that there are no gaps.
Test Your Key Fob:
Now, test your key fob to ensure it’s working correctly. Try locking and unlocking your doors remotely, using the panic button, and attempting to start your 2015 Jeep Cherokee. With a fresh battery, your key fob should be back to its optimal performance.
Beyond Battery Replacement:
If you’ve replaced the battery and your 2015 Jeep Cherokee key fob is still not working correctly, or if you’re experiencing more complex issues like intermittent starting problems even with new fobs, there might be other factors at play. It’s possible there could be an issue with the key fob programming, the vehicle’s receiver, or even the car battery itself. In these situations, consulting a qualified locksmith or dealership technician is recommended for further diagnosis and repair.
Replacing your 2015 Jeep Cherokee key fob battery is a simple maintenance task that can save you time and money. By following these easy steps, you can ensure your key fob is always ready to keep you connected to your vehicle.
