Lost or need to replace your 2009 Toyota Matrix key fob? The good news is you can program the remote portion of your key fob yourself right at home. This guide provides simple, step-by-step instructions to get your keyless entry working again for 2009, 2010, 2011, 2012, and 2013 Toyota Matrix models.
Important Notes Before You Begin:
- This programming method is specifically for the remote control functions (lock, unlock, panic).
- Key Cutting and Transponder Chip: This DIY programming will not program the transponder chip needed to start your car, nor will it cut the physical key. These services must be performed by a Toyota dealership or a qualified automotive locksmith.
- Smart Key Not Supported: This procedure is not for Toyota Matrix models equipped with a smart key system.
Step-by-Step Programming Instructions:
Follow these instructions carefully to program your 2009-2013 Toyota Matrix key fob:
- Preparation: Ensure the driver’s door is open and unlocked. Remove the key from the ignition switch.
- Insert and Remove Key (Twice): Within 5 seconds, insert your key into the ignition switch and remove it twice.
- Door Cycle (Twice): Within 40 seconds of step 2, close and then open the driver’s door twice.
- Insert and Remove Key (Once): Immediately insert the key into the ignition switch and remove it one time.
- Door Cycle (Twice Again): Within 40 seconds of step 4, close and then open the driver’s door twice again.
- Ignition and Door Closure: Insert the key into the ignition switch and close the driver’s door.
- Initiate Programming Mode: Switch the ignition ON then OFF.
- Once: To program a new remote while keeping existing programmed remotes.
- Twice: To program a new remote and erase all previously programmed remotes.
- Remove Key and Confirmation: Remove the key from the ignition switch. The system should now automatically lock and unlock the vehicle. The number of lock/unlock cycles indicates the programming mode selected (once, twice, or five times) and the number of remotes currently registered (up to four slow cycles).
- Remote Button Programming: Within 40 seconds, take your remote key fob and press and hold the LOCK and UNLOCK buttons simultaneously for 1.5 seconds.
- Lock Button Press: Within 3 seconds of releasing the buttons in step 9, press the LOCK button on the remote.
- Confirmation: The system should lock and unlock the vehicle once to confirm successful registration. Two lock/unlock cycles indicate registration failure.
- Program Additional Remotes (If Needed): If you have additional remote key fobs to program, repeat steps 9-11 within 40 seconds.
- Exit Programming Mode: To exit programming mode, simply open the driver’s door.
Important Programming Notes:
- Maximum Remotes: A maximum of 4 remote transmitters can be programmed to your 2009-2013 Toyota Matrix.
- Timing is Key: Ensure you complete each step within the specified time limits (5 seconds, 40 seconds, 3 seconds) for successful programming.
- Troubleshooting: If the system indicates registration failure (two lock/unlock cycles), double-check each step and try again. Ensure you are using a compatible remote for your Toyota Matrix.
By following these detailed instructions, you can easily program your 2009 Toyota Matrix key fob remote functions yourself. Remember to consult a Toyota dealer or automotive locksmith for key cutting and transponder programming to fully utilize your new key.
Image: Visual representation of key fob and ignition switch, illustrating steps for Toyota Matrix key fob programming.
