Programming your 2007 Dodge Durango key fob can be a straightforward process, potentially saving you a trip to the dealership. This guide provides clear, easy-to-follow instructions to program your key fob remote yourself. Whether you’re adding a new key fob or replacing an old one, understanding the programming procedure is essential.
Before you begin, it’s crucial to verify that your 2007 Dodge Durango was manufactured in the USA, as this programming procedure is specifically for US-built vehicles. Additionally, this method only works if you currently possess two working, programmed remote/keys. If you have fewer than two functioning keys, this DIY programming procedure will not be effective, and you will need to seek professional assistance.
If you meet these prerequisites, you can proceed with programming your 2007 Dodge Durango key fob by following these steps carefully:
-
Begin by using your first working programmed remote/key. Insert it into the ignition and turn the ignition switch to the ON position. It’s important to turn the ignition to ON, which activates the vehicle’s electronics, but do not start the engine. Hold the key in the ON position for approximately 5 seconds. After 5 seconds, turn the key back to the OFF position and remove it from the ignition.
-
Within 5 seconds of removing the first key, take your second working programmed remote/key and insert it into the ignition. Again, turn the ignition switch to the ON position, ensuring you do not crank the engine. At this point, observe the security light on your dashboard. Within about 10 seconds, the security light should begin to flash, and you may hear a chime. This indicates that the vehicle has entered programming mode. It’s worth noting that some 2007 Dodge Durango models may only flash the security light without a chime, so be sure to watch for the light even if you don’t hear a sound. Once you observe the flashing security light (and chime if applicable), turn the ignition switch to the OFF position and remove the second key.
-
Now, within 5 seconds, insert your new, correctly cut remote/key that you wish to program into the ignition. Turn the ignition switch to the ON position (do not start the engine). The security light should once again start flashing. Within 10 seconds, you should hear a chime, and then the security light should turn off. The security light turning off indicates that the new remote/key has been successfully programmed to your 2007 Dodge Durango. Turn the ignition switch to the OFF position and remove the newly programmed key.
-
The final step is to test the functionality of both the key and the remote. Start your 2007 Dodge Durango with the newly programmed key to ensure the immobilizer function is working correctly. Then, test all the remote functions – lock, unlock, panic, and any other buttons your key fob may have – to confirm that the remote programming was also successful.
If you encounter difficulties during this programming procedure, or if you prefer professional assistance, there are experienced key fob installers available in your area. You can use the search box below to locate a qualified professional who can program your 2007 Dodge Durango key fob for you. Simply enter your city name or zip code to find local experts.
