Is your 2010 Chevy Key Fob acting up? Maybe the buttons are sticky, the flip mechanism is loose, or the shell is damaged. Before you rush to a dealership and spend a fortune on a replacement, consider a simple DIY fix. This guide will walk you through disassembling and reassembling your 2010 Chevy key fob, a straightforward process that can often resolve common issues or allow you to replace the outer shell without needing a new key cut or programmed. All you’ll need is a small screwdriver and a few minutes of your time.
First, let’s get started by removing the battery. Locate the battery cover on your 2010 Chevy key fob. With the key flipped open, use your thumb in the space where the key sits to pop the battery cover off. Carefully remove the battery.
Next, you’ll need to gently pry open the key fob shell. Using a small flathead screwdriver, start at the top side of the key fob. Insert the screwdriver into the seam and gently pry to begin separating the two halves of the shell. If your key fob has already started to come apart, this step might be easier.
Continue prying along the backside of the 2010 Chevy key fob, near the metal keyring holder. Work slowly and carefully to ease the shell apart without damaging the plastic. You might find it helpful to hold the plastic part of the shell and push against the metal keyring portion to separate the halves.
Once the front face is free from the back face, be prepared for a slight spin. The internal spring mechanism will cause the two halves to rotate about two revolutions as they separate. This is normal and part of the key fob’s design.
Now that the shell is open, you can carefully remove the internal components. This includes the key itself and the electronic chip. Gently lift these components out of the front half of the key fob shell.
Reassembling your 2010 Chevy key fob is generally the reverse of disassembly, but with a key step to reset the spring mechanism.
Begin by placing the push button back into the key if it became separated. Then, insert the electronic chip back into the front half of the shell, ensuring it’s facing down in its designated spot. Position the key into its “out” or open position within the front shell.
Next, you’ll need to deal with the spring. Place the spring back into the push button area. It should seat securely into a locked position. Now, carefully position the back face of the key fob onto the spring. Ensure the small “foot” of the spring is correctly placed in its corresponding slot on the back face. This foot is crucial for the flip mechanism to work correctly.
Hold the key fob assembly together and rotate the back face counterclockwise. This action will wind the spring and create the outward spring force for the flip key. Rotate the back face approximately two full revolutions.
Finally, snap the two halves of the 2010 Chevy key fob shell back together. Press firmly until you hear a click, ensuring the case is securely closed. Finger pressure should be sufficient to close it properly.
By following these steps, you can disassemble and reassemble your 2010 Chevy key fob in about 5 minutes. This simple process can sometimes improve the fit and feel of your key fob, resolving issues like looseness. If you need to replace the entire shell, knowing how to disassemble your key fob allows you to easily swap the internal components into a new shell, saving you significant money compared to dealership replacement costs.
For replacement shells or uncut keys for your 2010 Chevy key fob, you can explore options from online retailers. This DIY approach is a cost-effective way to maintain your key fob and avoid unnecessary expenses.
