Are you looking to program a new key fob for your 2006 Chrysler Town & Country without the expensive dealership visit? It’s entirely possible to do it yourself, saving you both time and money. If you already have two working keys, the process is surprisingly straightforward. This guide will walk you through programming a new key fob and key for your 2006 Chrysler Town & Country, empowering you to handle this task with ease.
DIY Key Fob Programming for Your 2006 Chrysler Town & Country
Programming a new key fob for your Chrysler Town & Country can be accomplished at home with a few simple steps, provided you have two currently programmed keys. This method utilizes your vehicle’s existing system to recognize and synchronize with the new key fob.
What You’ll Need
Before you begin, ensure you have the necessary items:
- Two Valid, Programmed Keys: You must have two keys that already work with your 2006 Chrysler Town & Country. These are essential for initiating the programming sequence.
- New Key Fob and Key Blank: Purchase a compatible blank key fob and key. These can often be found online at reasonable prices. Make sure the blank key is cut to match your vehicle’s ignition. You can get this done at most locksmiths or key-cutting services.
Step-by-Step Programming Instructions
Follow these steps carefully to program your new key fob and key:
- Insert First Valid Key and Turn Ignition ON: Place your first working key into the ignition. Turn the ignition switch to the “ON” position. Make sure you do not start the engine. Leave the key in the “ON” position for at least 3 seconds, but no longer than 15 seconds.
- Turn Ignition OFF and Remove First Key: After the specified time, turn the ignition switch to the “OFF” position. Remove the first key from the ignition.
- Insert Second Valid Key and Turn Ignition ON: Within 15 seconds of removing the first key, insert your second working key into the ignition switch. Turn the ignition to the “ON” position.
- Wait for Chime and Flashing Theft Alarm Light: After approximately ten seconds, you will hear a chime sound. Simultaneously, the Theft Alarm Light on your dashboard will start to flash.
- Turn Ignition OFF and Remove Second Key: Turn the ignition switch to the “OFF” position and remove the second key from the ignition.
- Insert Blank Key and Turn Ignition ON: Within 60 seconds of removing the second key, insert the newly cut blank key into the ignition switch. Turn the ignition to the “ON” position.
- Wait for Chime and Theft Alarm Light Indication: After about 10 seconds, you will hear a single chime. The Theft Alarm Light will stop flashing, illuminate for 3 seconds, and then turn off. This sequence confirms that your new key and key fob have been successfully programmed.
Your new key and key fob should now be programmed to your 2006 Chrysler Town & Country. Test the key to ensure it starts the vehicle and test the key fob to verify the remote functions are working correctly.
Important Notes
- Lost Programmed Key: If you have lost one of your programmed keys and no longer have two working keys, you will need to visit a dealership or a qualified locksmith for programming services. The DIY procedure requires two existing valid keys to initiate.
- Erasing Lost Keys: If a programmed key has been lost or stolen, it’s recommended to visit your Chrysler dealer. They can erase all existing keys from the system’s memory and reprogram your remaining keys, along with your new one. This crucial step prevents the lost key from being used to start your vehicle, enhancing your vehicle’s security. All keys you intend to use with the vehicle must be present at the dealership during this reprogramming service.
- Maximum Keys: You can program up to a total of 8 keys for your 2006 Chrysler Town & Country using this procedure.
By following these steps, you can easily program a new key fob for your 2006 Chrysler Town & Country, saving yourself the expense of professional programming when you have two working keys available.
