Lost your 1999 Honda Crv Key Fob or need to program a replacement? Don’t worry, you can easily program your key fob yourself right at home. This guide provides simple, step-by-step instructions to get your keyless entry working again in minutes. Programming your 1999 Honda CRV key fob is a straightforward process, saving you time and money compared to dealership programming.
Programming Your 1999 Honda CRV Key Fob: Easy Steps
Before you begin, it’s important to note that initiating the programming sequence will erase all previously programmed remotes. Therefore, you will need to reprogram all of your key fobs during this process. Ensure you have all remotes you intend to use ready before starting. Also, each step must be completed within 5 seconds of the last to avoid the system exiting programming mode.
Here’s how to program your 1999 Honda CRV key fob:
-
Turn the Ignition to ON (Position II): Insert your key into the ignition and turn it to the “ON” position (II). This is the position right before starting the engine, where the dashboard lights illuminate.
-
Press the Lock or Unlock Button: Take one of your key fobs (it can be a new, un-programmed fob) and press either the “LOCK” or “UNLOCK” button.
-
Turn the Ignition to LOCK (Position 0): Turn the ignition key back to the “LOCK” position (0), which is the position where you can remove the key.
-
Repeat Steps 1-3 Two More Times: Repeat steps 1, 2, and 3 two more times, using the same key fob you used in step 2. Essentially, you are cycling the ignition ON, pressing a button, and turning OFF, three times in total.
-
Turn the Ignition to ON (Position II) Again: Turn the ignition switch to the “ON” position (II) for the final time.
-
Press the Lock or Unlock Button (Same Remote): Press the “LOCK” or “UNLOCK” button on the same remote you have been using throughout these steps. If you have successfully entered programming mode, you should hear the power door locks cycle (lock and then unlock). This confirms you are ready to program your remotes.
-
Program Each Remote: Now, take each remote you want to program, and press the “LOCK” or “UNLOCK” button on each one. After pressing a button on each remote, you should hear the door locks cycle again, indicating that the system has accepted and learned that remote’s signal.
-
Turn the Ignition to LOCK (Position 0) to Exit: Once you have programmed all desired remotes, turn the ignition switch to the “LOCK” position (0) to exit the programming mode. The door locks may cycle one last time to confirm exit.
-
Test Your Remotes: Finally, test each of your programmed key fobs to ensure they are working correctly. Press the “LOCK” and “UNLOCK” buttons to verify that they control the door locks as expected.
These instructions should help you easily program your 1999 Honda CRV key fob. If you are still having trouble, double-check each step and ensure you are completing them within the 5-second time limit. For replacement key fobs for your Honda CRV and other vehicles, visit Keylessentryremotefob.com.
