Is your 2000 Chevy Impala key fob not working? Or perhaps you’ve purchased a new replacement key fob and need to program it to your vehicle? Don’t worry, programming your 2000 Impala Key Fob is a straightforward process you can do yourself, without a trip to the dealership. This guide will walk you through each step to get your key fob working perfectly with your 2000 Chevrolet Impala.
Step-by-Step Programming Guide for Your 2000 Impala Key Fob
Before you begin, ensure you have all your key fobs that you want to program to your vehicle. This procedure will program up to four key fobs.
Step 1: Initiate Programming Mode
-
Turn your ignition key to the “ACC” or “ON” position. Make sure the engine is not started and the radio is turned off.
-
Locate the “DISP” button on your radio. Press and hold this button for approximately five seconds. You’ll know you’ve held it long enough when “settings” appears on the radio display.
-
Use the “SEEK” up or down arrow buttons, also located on your radio, to scroll through the settings menu. Continue pressing until “FOB PROG” is displayed on your radio screen.
-
Once “FOB PROG” is visible, press the “PREV” or “NEXT” button to enter the sub-menu. You will see an asterisk next to the current selection. “BEGIN” will then appear on the display, indicating you are ready to start programming.
Step 2: Program the Key Fob
-
Press the “DISP” button again to initiate the programming sequence. The display will flash “PUSH FOB”.
-
Take your first key fob that you want to program. Simultaneously press and hold both the “LOCK” and “UNLOCK” buttons on the key fob for about 15 seconds.
-
Listen for a chime sound. This chime indicates that the vehicle has successfully learned the signal from your key fob and it is now programmed.
Step 3: Program Additional Key Fobs (Optional)
If you have additional key fobs to program (up to a maximum of four), repeat Step 2 for each additional fob. You do not need to press the “DISP” button again. Simply proceed to press and hold the “LOCK” and “UNLOCK” buttons on the next key fob you wish to program. The vehicle will chime after each successful programming.
Step 4: Exit Programming Mode
-
To exit the key fob programming mode, use the “SEEK” up or down arrows to scroll through the menu again until “EXIT” is displayed on the radio screen.
-
Press the “DISP” button one last time to confirm and exit programming mode. You should hear a chime to verify that you have successfully exited.
Congratulations! You have now successfully programmed your 2000 Impala key fob. Test each button on your key fob to ensure it is working correctly with your vehicle’s door locks and other remote functions.
If you need a replacement key fob for your 2000 Chevy Impala, or for any other vehicle, visit Keylessentryremotefob.com for a wide selection of quality key fobs and remotes.
