Lost or need to replace your 2001 Honda Odyssey Key Fob? Programming a new keyless entry remote for your Honda Odyssey can be a straightforward process you can do yourself. This guide provides easy-to-follow programming instructions for both the EX and LX models of the 2001 Honda Odyssey.
Programming Your 2001 Honda Odyssey Key Fob – EX Model (Factory System)
This procedure is for 2001 Honda Odyssey EX models equipped with the factory-installed keyless entry system. Keep in mind that the system can store up to three remotes. Programming a fourth remote will cause the oldest programmed remote to be erased from the system’s memory.
Follow these steps to program your key fob:
-
Turn the ignition to the ON position (II). This is the position right before you would start the engine.
-
Within 4 seconds of turning the ignition ON, press the LOCK or UNLOCK button on your remote. Ensure you are pointing the remote towards the receiver, which is typically located near the glove box area.
-
Within 4 seconds of pressing the remote button, turn the ignition to the LOCK position (0). This is the OFF position.
-
Repeat steps 1, 2, and 3 two more times using the same keyless remote you used in step 2. You will be cycling the ignition ON, pressing the remote button, and then turning the ignition OFF, for a total of three times.
-
Within 4 seconds of the last ignition cycle, turn the ignition switch back to the ON position (II).
-
Within 4 seconds, press the LOCK or UNLOCK button again on the same remote. At this point, the power door locks should cycle (lock then unlock). This indicates that you have successfully entered programming mode. Press the LOCK or UNLOCK button once more.
-
Program additional remotes (if needed). If you have more remotes to program, press the LOCK or UNLOCK button on each of them, one at a time. After pressing a button on each remote, the door locks should cycle again, confirming that the system has accepted the new remote’s signal.
-
Exit programming mode. Turn the ignition switch to the LOCK position (0). This will finalize the programming and exit the key fob programming mode.
-
Test your remotes. Press the LOCK and UNLOCK buttons on each programmed remote to ensure they are working correctly and controlling the door locks.
Programming Your 2001 Honda Odyssey Key Fob – LX Model (Dealer System)
For 2001 Honda Odyssey LX models that are equipped with a dealer-installed keyless entry system, the programming procedure is slightly different. Use the following steps for LX models:
-
Turn the ignition switch to the ON position (II).
-
Press the LOCK or UNLOCK button on one of the remotes. It is important to note that even an unprogrammed remote can be used for this step.
-
Turn the ignition switch to the LOCK position (0).
-
Repeat steps 1, 2, and 3 two more times using the same keyless remote from step 2.
-
Turn the ignition switch to the ON position (II) again.
-
Press the LOCK or UNLOCK button on the same remote used previously. The power door locks should cycle to indicate that you have entered programming mode.
-
Program additional remotes. Press the LOCK or UNLOCK button on each additional remote you wish to program. The door locks should cycle after each remote button press to confirm successful programming.
-
Exit programming mode. Turn the ignition switch to the LOCK position (0).
-
Test all programmed remotes to verify they are functioning as expected.
By following these instructions, you should be able to successfully program your 2001 Honda Odyssey key fob and regain keyless entry functionality for your vehicle. If you encounter issues, double-check each step and ensure you are using a compatible key fob for your Honda Odyssey model.
