Is your 2007 Corvette key fob acting up? A common culprit is a dead or dying battery. Don’t rush to the dealership for an expensive replacement. Changing the battery in your C6 Corvette key fob is a straightforward task you can easily handle at home. This guide will walk you through each step, ensuring a smooth and successful battery replacement, saving you time and money.
First, you’ll need to gather a couple of items. The most important is the correct replacement battery. You’ll need a CR2032 battery, which is widely available at most drugstores, supermarkets, and auto parts stores. It’s a good idea to buy batteries in packs of two, so you’ll have a spare for the future or to replace the battery in a second fob.
Besides the battery, you’ll need a thin, flat object to help open the key fob. A quarter coin works perfectly and is less likely to damage the plastic casing compared to a screwdriver or other sharp tools.
Now, let’s get started with the battery replacement process:
Step 1: Detach the Key Ring
Before you can open the key fob, you’ll need to remove the key ring. This provides clear access to the opening slot and prevents accidental damage or obstruction. Simply slide the key ring off the fob and set it aside.
Step 2: Locate the Opening Slot
Examine your Corvette key fob closely. On the front side, you’ll find a small slot specifically designed for opening the case.
Step 3: Pry Open the Key Fob
Insert the edge of your quarter coin into the slot. Apply gentle but firm pressure and twist the coin to begin prying the fob open.
Step 4: Separate the Fob Halves Evenly
Once you’ve created a small opening, carefully work the quarter around the seam of the key fob. The 2007 Corvette key fob has a tight, water-resistant seal. To avoid damaging the case, open it evenly from side to side, gradually separating the two halves. Avoid using excessive force on one point, as this could crack the plastic.
Step 5: Observe the Water Seal
Notice the rubber water seal around the edge of the fob casing. This seal is designed to protect the electronics from moisture. Be careful not to damage it during the opening process to maintain the water resistance when reassembling.
Step 6: Locate the Battery
With the fob open, you’ll see the internal components. One half will house the electronic circuit board, and the other will contain the battery.
Step 7: Remove the Old Battery
The battery is held in place by small clips. Gently use a small screwdriver or your fingernail to pry under the edge of the battery. Lift it carefully to dislodge it from the clips.
Step 8: Install the New Battery
Take your new CR2032 battery and ensure the positive (+) side is facing down, matching the orientation of the old battery. Slide the new battery under two of the retaining clips, and then gently press down on the other side until it clicks securely into place under the third clip.
Step 9: Reassemble the Key Fob
Align the two halves of the key fob, starting at the end opposite the key ring slot. There are small tabs that need to fit into corresponding slots.
Press the two halves firmly together, working your way around the edges. You should hear a click as the case snaps back into place. Ensure there are no gaps along the seam, indicating a proper seal.
Step 10: Test Your Key Fob
Finally, test all the buttons on your key fob – lock, unlock, trunk release, and panic alarm – to confirm it’s working correctly. Also, ensure your car starts with the fob.
Tips for a Smooth Battery Replacement:
- Work on a clean surface: This prevents dirt or debris from getting inside the key fob.
- Be gentle: Avoid using excessive force when opening the fob to prevent damage.
- Double-check battery orientation: Ensure the positive (+) side of the new battery is facing the correct way.
- Replace one fob at a time: Keep one working key fob until you’ve confirmed the other replacement is successful.
Replacing your 2007 Corvette key fob battery is a simple maintenance task that any owner can perform. By following these steps, you can keep your key fob functioning perfectly and avoid unnecessary trips to the mechanic.
