Lost your key fob or need to program a new remote for your 2007 GMC Yukon Denali? Don’t worry, programming a key fob for your vehicle can be done easily at home without a trip to the dealership. This guide provides step-by-step instructions for programming your 2007 GMC Yukon Denali keyless entry remote, ensuring you regain convenient access to your vehicle. The process varies slightly depending on whether your Yukon Denali is equipped with Driver Information Center (DIC) buttons. Follow the procedure that matches your vehicle’s configuration below.
Programming Instructions for 2007 GMC Yukon Denali with Driver Information Center Buttons
If your 2007 GMC Yukon Denali has Driver Information Center buttons on the steering wheel, use this procedure to program your key fob:
-
Start the Vehicle and Access DIC: Insert your key into the ignition and turn it to the “ON” position. This will allow you to access the Driver Information Center through the steering wheel controls.
-
Navigate to Remote Key Relearn: Press the vehicle information button repeatedly until you see “PRESS TO RELEARN REMOTE KEY” displayed on the Driver Information Center screen.
-
Initiate Remote Learning Mode: Press the set/reset button. The display will change to “REMOTE KEY LEARNING ACTIVE”, indicating that your Yukon Denali is now ready to learn the new key fob.
-
Program the Key Fob: Take your keyless remote and simultaneously press and hold both the Lock and Unlock buttons for approximately 15 seconds. You should hear a chime sound, confirming that the remote has been successfully programmed.
-
Program Additional Remotes (Optional): If you need to program additional key fobs, repeat step 4 immediately. Your 2007 GMC Yukon Denali can be programmed to recognize up to eight remotes.
-
Exit Programming Mode and Test: Turn the ignition key to the “OFF” position and remove the key from the ignition. Test each programmed remote to ensure they are working correctly by locking and unlocking your doors and activating other remote functions.
Programming Instructions for 2007 GMC Yukon Denali without Driver Information Center Buttons
For 2007 GMC Yukon Denali models without Driver Information Center buttons, use this procedure to program your key fob. Ensure your vehicle is in Park (P) and the key is in the “ON” position (turned as far as it will go without starting the engine) before beginning:
-
Access Relearn Remote Key Display: Press and release the trip odometer reset stem located on the instrument panel until “RELEARN REMOTE KEY” is displayed.
-
Activate Remote Learning Mode: Press and hold the trip odometer reset stem for approximately three seconds. The message “REMOTE KEY LEARNING ACTIVE” will appear, indicating the vehicle is in key fob programming mode.
-
Program the Key Fob: On your first keyless remote, press and hold the Lock and Unlock buttons at the same time for about 15 seconds. A chime will sound to signal that the remote programming is complete and successful.
-
Program Additional Remotes (Optional): To program extra key fobs, immediately repeat step 3 for each additional remote. Up to eight key fobs can be programmed to your 2007 GMC Yukon Denali.
-
Exit Programming and Verify: Turn the key to the “OFF” position and remove it from the ignition. Thoroughly test all programmed remotes to confirm they are functioning as expected, controlling door locks and other remote features.
By following these straightforward steps, you can easily program your 2007 Gmc Yukon Denali Key Fob and regain full keyless entry functionality for your vehicle. Enjoy the convenience of your programmed remote!
