Is your 2007 GMC Yukon key fob not working as expected, or have you recently replaced it? Programming your key fob is a straightforward process you can accomplish at home, saving you a trip to the dealership. This guide provides clear instructions for programming your 2007 Yukon Key Fob, ensuring you regain full remote functionality quickly and easily.
Procedure #1: For Yukon Models With Driver Information Center
This procedure applies to 2007 GMC Yukon vehicles equipped with a driver information center. You can identify this feature by checking for buttons on your steering wheel that include an “i” symbol.
- Begin by inserting your key into the ignition. Turn the key to the “on” position, but do not start the engine.
- Locate the “Information” button on your steering wheel and press it repeatedly until you see “Relearn Remote Key” displayed in the driver information center.
- Once “Relearn Remote Key” is displayed, find the “set/reset” button (often marked with a checkmark symbol) and press it. Continue pressing until the display changes to “Remote Key Learning Active”.
- Immediately press and hold both the “Lock” and “Unlock” buttons simultaneously on the key fob you are programming. Hold these buttons until the vehicle emits two chimes. These chimes indicate successful programming of that key fob. If you have additional or existing key fobs to program, repeat this step 4 for each one. It’s crucial to program all remotes you intend to use at this stage.
- Finally, turn the ignition key to the “off” position. This action will exit the key fob programming mode.
Procedure #2: For Yukon Models Without Driver Information Center
If your 2007 GMC Yukon does not have a driver information center, use this procedure to program your key fob.
- Insert the ignition key and turn it to the “on” position, ensuring you do not start the engine.
- Locate the trip odometer reset button, typically found on the instrument panel. Press and release this button until “Relearn Remote Key” is displayed (this display will appear in the area where your odometer is shown).
- Press and hold the trip odometer reset button until the display changes to “Remote Key Learning Active”.
- Take the key fob you wish to program and press and hold the “Lock” and “Unlock” buttons at the same time. Continue holding until the vehicle chimes, confirming successful programming. Repeat this step 4 for every key fob you need to program, including any previously working remotes. Programming all remotes at once is essential.
- Turn the ignition key to the “off” position to exit the programming mode.
Important Note: If you encounter any issues with your existing key fobs after programming a new one, it is likely because step 4 requires you to program all desired remotes in a single programming session. Ensure you repeat step 4 for every key fob you want to function with your 2007 GMC Yukon.
By following these procedures, you should be able to easily program your 2007 GMC Yukon key fob and restore full remote access to your vehicle.
