Lost or broken your 2008 Cadillac SRX key fob? Don’t worry, getting a replacement and programming it yourself is easier than you might think. As a car repair expert at keyfobprog.com, I’m here to guide you through the simple steps to program a new key fob for your 2008 Cadillac SRX, saving you time and money.
Before we begin, ensure you have a compatible key fob for your 2008 Cadillac SRX. You can find these at various automotive parts retailers or online. Once you have your new key fob, follow the instructions below that correspond to whether your vehicle is equipped with a Driver Information Center (DIC) or not.
Procedure #1: Programming with Driver Information Center (DIC)
This procedure applies to 2008 Cadillac SRX models that feature a Driver Information Center. The DIC is typically controlled by buttons located to the right of your steering wheel, often marked with a vehicle icon and the letter “i”.
-
Ignition Activation: Insert your key into the ignition. Turn the key to the “ON” position. This is the position just before you would start the engine.
-
Access Relearn Mode: Locate the vehicle information button on your DIC controls. Press this button repeatedly until you see the message “PRESS TO RELEARN REMOTE KEY” displayed on the DIC screen.
-
Initiate Learning: Once “PRESS TO RELEARN REMOTE KEY” is displayed, press the set/reset button. This button usually has a checkmark symbol. Continue pressing until the DIC screen shows “REMOTE KEY LEARNING ACTIVE”. Your Cadillac SRX is now in programming mode, ready to learn the new key fob.
-
Program First Remote: Take your first key fob remote. Simultaneously press and hold both the LOCK and UNLOCK buttons. Hold them down for approximately 15 seconds. You should hear an audible chime or acoustic signal from your vehicle, indicating successful programming of this key fob.
-
Program Additional Remotes: If you have more key fobs to program, repeat step 4 immediately for each additional remote. It’s crucial to program all remotes you intend to use at this time, including any existing working remotes. The system can accommodate up to 8 key fobs in total.
-
Exit Programming Mode: To finalize the programming, turn the ignition switch to the “OFF” position and remove the key from the ignition.
-
Test Your Remotes: Thoroughly test all programmed key fobs to ensure they are working correctly with your 2008 Cadillac SRX.
Procedure #2: Programming without Driver Information Center (DIC)
If your 2008 Cadillac SRX model does not have a Driver Information Center, use this procedure to program your key fob.
-
Ignition Activation: Insert the key into the ignition and turn it to the “ON” position, just before starting the engine.
-
Enter Relearn Mode: Locate the trip odometer reset button, typically found on the instrument panel cluster. Press and release this button repeatedly until the display shows “RELEARN REMOTE KEY”.
-
Activate Learning Mode: Once “RELEARN REMOTE KEY” is displayed, press and hold the trip odometer reset button for about 3 seconds. The display will change to “REMOTE KEY LEARNING ACTIVE”, indicating your vehicle is now in key fob programming mode.
-
Program First Remote: Take your first key fob. Press and hold the LOCK and UNLOCK buttons simultaneously for approximately 15 seconds. Listen for the acoustic signal from your Cadillac SRX, confirming successful programming.
-
Program Additional Remotes: Repeat step 4 for any additional key fobs you need to program, including your original remotes. Remember, you must program all remotes at once, up to a maximum of 8.
-
Exit Programming: Turn the ignition to the “OFF” position and remove the key to exit the programming sequence.
-
Test All Remotes: Verify that all programmed key fobs are functioning correctly by testing all buttons on each remote.
Troubleshooting and Professional Help
If you encounter difficulties programming your 2008 Cadillac SRX key fob, double-check each step and ensure you are using a compatible key fob. If you prefer professional assistance, you can search online for qualified key fob installers in your area.
By following these straightforward procedures, you can easily program a new key fob for your 2008 Cadillac SRX and regain full remote functionality for your vehicle.
