Lost your key fob or need to program a new one for your 2009 Mitsubishi Galant? You can actually program a new key fob yourself, saving time and money. This guide provides straightforward instructions for programming both the key and remote functions of your 2009 Mitsubishi Galant Key Fob. Before you begin, ensure you have a new key cut by a locksmith that is compatible with your Mitsubishi Galant.
Programming the Key Portion of Your 2009 Mitsubishi Galant Key
This section will guide you through programming the transponder chip within your new key, allowing it to start your 2009 Mitsubishi Galant. You will need at least one working key to perform these steps.
- Insert Working Key 1: Place your existing, working key into the ignition cylinder.
- Turn Ignition ON: Turn the ignition to the “ON” position (without starting the engine) and hold for 5 seconds. Then, turn the ignition back to the “OFF” position and remove the key.
- Insert Working Key 2: Within 10 seconds of removing the first key, insert a second working key into the ignition and turn it to the “ON” position. You should see the security light on your dashboard flash twice. Turn the ignition back to “OFF” and remove the second working key.
- Insert New Key: Within 10 seconds, insert your new, unprogrammed key into the ignition and turn it to the “ON” position.
- Wait for Security Light: The security light will illuminate for approximately 3 seconds. This indicates that your new key has been successfully programmed to start your 2009 Mitsubishi Galant.
- Program Additional Keys (Optional): If you have more new keys to program, immediately repeat steps 4 and 5. Remember, all new keys must be programmed within 30 seconds of the security light flashing twice in step 3.
- Exit Programming Mode: To exit the key programming mode, simply leave the ignition switched to the “ON” position for longer than 30 seconds.
Programming the Remote Portion of Your 2009 Mitsubishi Galant Key Fob
After programming the key portion, you’ll need to program the remote functions (lock, unlock, panic) of your 2009 Mitsubishi Galant key fob. This process involves using the OBD-II data port in your vehicle.
-
Locate the OBD-II Data Port: Find the OBD-II data port. It’s typically located under the driver’s side dashboard, usually to the right of the steering column.
-
Insert Key and Turn to OFF: Insert your key into the ignition, but leave it in the “OFF” position.
-
Prepare Jumper Wire: Ensure that terminals 1 and 4 are present in your OBD-II data port. Use a suitable jumper wire to connect terminals 1 and 4. Keep the jumper wire connected throughout the entire remote programming procedure. It is crucial to correctly identify terminals 1 and 4 before proceeding.
-
Press Hazard Switch: Within 10 seconds of connecting the jumper wire, press the Hazard Switch 6 times. At this point, the doors should automatically lock and unlock once. This indicates that your 2009 Mitsubishi Galant system has entered programming mode for the remote.
-
Press LOCK Button on Remote: On the key fob you want to program, press the “LOCK” button three times within 10 seconds. If programming is successful, the doors will lock and unlock once again.
-
Program Additional Remotes (Optional): Repeat step 5 for any additional remotes you need to program, up to a maximum of 4 remotes (including any previously programmed remotes). After each successful remote programming, the doors will lock and unlock once.
-
Disconnect and Exit: Disconnect the jumper wire from the OBD-II data port and remove the key from the ignition.
By following these steps, you should be able to successfully program your 2009 Mitsubishi Galant key fob. Enjoy the convenience of your newly programmed key and remote!
