Are you looking to program a new key fob for your 2009 Scion xB? Losing or damaging your key fob can be a frustrating experience. Fortunately, programming a replacement for your 2009 Scion xB is a process you can often undertake yourself at home, saving time and money. This comprehensive guide provides you with easy-to-understand, step-by-step instructions to program your 2009 Scion xB key fob remote quickly and effectively.
DIY Programming Instructions for Your 2009 Scion xB Key Fob
Before starting the programming sequence, gather all the key fobs you intend to use with your 2009 Scion xB. It’s crucial to program all remotes in one session to ensure they all function correctly. Carefully follow these instructions for successful 2009 Scion Xb Key Fob Programming:
-
Initial Setup: Begin with your 2009 Scion xB key removed from the ignition. Open and unlock the driver’s side door only. Make sure all other doors, including the rear hatch or trunk, are completely closed.
-
Key Insertion and Removal (Cycle 1): Within 5 seconds of opening the driver’s door, insert the key into the ignition switch and immediately pull it out. Repeat this action once more, for a total of two insertions and removals within 5 seconds.
-
Door Open/Close Cycle (Cycle 1): Immediately after the key cycles, close the driver’s side door, and then open it again. Repeat this sequence, closing and opening the driver’s door a second time.
-
Key Insertion and Removal (Cycle 2): Insert the key into the ignition switch one more time, and then remove it.
-
Door Open/Close Cycle (Cycle 2): Again, close the driver’s side door, and then open it. Repeat this, closing and opening the driver’s door for a second time.
-
Final Key Insertion (Leave In): Insert the key into the ignition switch for the last time and leave it in the ignition cylinder.
-
Door Closure: Close the driver’s side door.
-
Ignition On/Off Cycle: Turn the ignition switch to the ‘ON’ position, and then immediately turn it back to the ‘OFF’ position. Do not start the engine.
-
Key Removal: Remove the key from the ignition switch.
-
Confirmation of Programming Mode: At this point, the door locks on your 2009 Scion xB should automatically cycle (lock and then unlock). This lock cycling sequence confirms that your vehicle has successfully entered key fob programming mode.
-
Programming the First Remote: Take the first key fob you wish to program. Press and hold down both the ‘LOCK’ and ‘UNLOCK’ buttons simultaneously for approximately 1.5 seconds. After releasing both buttons, immediately press and hold only the ‘LOCK’ button for about 2 seconds.
-
Remote Programming Confirmation: The door locks will cycle once again to confirm that the remote has been successfully programmed. If you have additional 2009 Scion xB key fobs to program, repeat step 11 for each additional remote.
-
Exit Programming Mode: Open the driver’s side door. Opening the door concludes the key fob programming procedure for your 2009 Scion xB. Test all programmed key fobs to ensure they are working correctly.
Professional 2009 Scion xB Key Fob Programming Assistance
If you experience any difficulties during the 2009 Scion xB key fob programming process, or if you would prefer to have a professional handle the programming for you, there are local automotive locksmiths and dealerships that offer key fob programming services. You can easily locate a professional by searching online for “key fob programming near me” or “automotive locksmith [your city/zip code]”. For replacement key fobs and remotes, consider visiting Keylessentryremotefob.com for a wide selection of options compatible with your 2009 Scion xB.
