Lost your key fob or need to program a new one for your 2009 Chevrolet Silverado? Don’t worry, programming your 2009 Silverado Key Fob can be done easily at home without a trip to the dealership. This guide provides simple, step-by-step instructions to get your key fob working quickly. Whether you’re adding an extra remote or replacing a lost one, follow these methods tailored for your Silverado model. You can purchase a replacement 2009 Silverado key fob at Keylessentryremotefob.com if needed.
Programming Instructions for 2009 Chevy Silverado Key Fob
The programming procedure slightly varies depending on whether your 2009 Chevy Silverado is equipped with Driver Information Center (DIC) buttons. Follow the instructions that match your vehicle’s configuration.
Procedure for Silverado Models WITH Driver Information Center Buttons
If your 2009 Silverado has buttons on the steering wheel that control the Driver Information Center, use this procedure. This information can also be found in your owner’s manual under the Driver Information Center section.
-
Turn Ignition to ON: Insert your key into the ignition and turn it to the “ON” position. This is the position right before you start the engine. Ensure you can access the Driver Information Center display.
-
Access Remote Relearn Mode: Press the vehicle information button on the steering wheel repeatedly until you see “PRESS TO RELEARN REMOTE KEY” displayed in the DIC.
-
Initiate Learning Mode: Press and hold the set/reset button until the DIC displays “REMOTE KEY LEARNING ACTIVE”. The vehicle is now in programming mode.
-
Program First Key Fob: Immediately press and hold both the lock and unlock buttons on your first 2009 Silverado key fob simultaneously for approximately 15 seconds. You will hear a chime sound, indicating that the key fob has been successfully programmed.
-
Program Additional Key Fobs (Optional): If you need to program additional 2009 Silverado key fobs, repeat step 4 for each additional remote. You can program up to eight remotes for your vehicle.
-
Exit Programming Mode: Turn the ignition key to the “OFF” position and remove the key from the ignition.
-
Test Remotes: Test all programmed key fobs to ensure they are working correctly by locking and unlocking your doors and activating other remote functions.
Procedure for Silverado Models WITHOUT Driver Information Center Buttons
If your 2009 Chevy Silverado does not have Driver Information Center buttons, use this procedure.
-
Prepare Vehicle: Ensure your vehicle is in Park (P) and the ignition key is in the “ON” position. This is as far as you can turn the key without starting the engine.
-
Enter Relearn Mode: Press and release the trip odometer reset stem repeatedly until “RELEARN REMOTE KEY” is displayed.
-
Activate Learning: Press and hold the trip odometer reset stem for about three seconds. The display will change to “REMOTE KEY LEARNING ACTIVE”, indicating the system is ready to program.
-
Program First Key Fob: Press and hold the lock and unlock buttons on your first keyless remote simultaneously for approximately 15 seconds. A chime will sound to confirm successful programming.
-
Program Additional Key Fobs (Optional): To program more remotes, repeat step 4 for each additional 2009 Silverado key fob you wish to program. The system supports up to eight remotes.
-
Exit Programming Mode & Test: Turn the ignition key to the “OFF” position and remove it. Test each programmed remote to verify proper operation.
By following these straightforward steps, you can easily program your 2009 Chevy Silverado key fob and regain full remote access to your vehicle. For replacement key fobs and other automotive key solutions, remember to visit Keylessentryremotefob.com.
