Programming your 2010 GMC Sierra key fob can be a straightforward process, often achievable without professional assistance. This guide provides comprehensive instructions for programming your key fob remote, ensuring you regain full access and control over your vehicle’s features. Whether you are replacing a lost fob or adding an extra one, follow these procedures to program your 2010 GMC Sierra key fob quickly and efficiently.
Procedure #1: For Vehicles With Driver Information Center (DIC)
This procedure applies if your 2010 GMC Sierra is equipped with a Driver Information Center, typically identified by buttons on the steering wheel featuring an “i” symbol.
-
Initiate Ignition: Insert your key into the ignition and turn it to the “on” position. It’s crucial not to start the engine at this stage. Simply turn the key to the point where the electrical systems of the car are active.
-
Access Relearn Remote Key Menu: Locate the “Information” button on your steering wheel. Press this button repeatedly until the Driver Information Center display shows “Relearn Remote Key”.
-
Activate Learning Mode: Once “Relearn Remote Key” is displayed, press the “set/reset” button (often marked with a checkmark symbol). Continue pressing until the display changes to “Remote Key Learning Active”. The vehicle is now in programming mode, ready to learn the new key fob.
-
Program Key Fob: Take the key fob you wish to program and simultaneously press and hold both the “Lock” and “Unlock” buttons. Maintain pressure on both buttons until the vehicle emits two chimes. These chimes confirm that the key fob has been successfully programmed. If you have additional key fobs (new or existing) to program, repeat this step 4 immediately for each fob. It’s important to program all fobs you intend to use at this stage to ensure they all function correctly.
-
Exit Programming Mode: Turn the ignition key to the “off” position. This action will exit the key fob programming mode. Test each programmed key fob to verify they lock and unlock the doors effectively.
Procedure #2: For Vehicles Without Driver Information Center
If your 2010 GMC Sierra does not have a Driver Information Center, use this alternative procedure to program your key fob.
-
Turn Ignition to “On”: Insert the key into the ignition and turn it to the “on” position, without starting the engine. Ensure the vehicle’s electrical system is active.
-
Access Relearn Remote Key: Locate the trip odometer reset button, usually found on the instrument panel cluster. Press and release this button multiple times until the display shows “Relearn Remote Key”.
-
Engage Learning Activation: Press and hold the trip odometer reset button until the display changes to “Remote Key Learning Active”. The vehicle is now ready to learn the key fob signal.
-
Program Remote: Take the key fob to be programmed and press and hold both the “Lock” and “Unlock” buttons simultaneously. Keep holding until the vehicle chimes, signaling successful programming. For any additional key fobs, including previously working ones, repeat this step 4 immediately to program them all in the same session. This ensures all desired remotes are recognized by your vehicle.
-
завершение программирования: Turn the ignition key to the “off” position to exit the programming sequence. Test all programmed key fobs to confirm they are working as expected.
Important Note: It is crucial to program all of your key fobs (both new and existing) during a single programming session. Failure to do so may result in previously programmed remotes no longer functioning.
If you encounter difficulties programming your key fob, or prefer professional assistance, consider using a local key fob programming service. You can search online for “key fob programming near me” to find qualified technicians in your area.
[ ]
[ ]
