Replacing your 2012 Cadillac SRX key fob doesn’t have to be a dealership-exclusive task. If you’ve purchased a new key fob for your Cadillac SRX, you can program it yourself right at home, provided you have a keyless access system. This guide will walk you through the steps to program a new key fob for your 2012 Cadillac SRX when you don’t have a recognized transmitter. Please note that this procedure is specifically for vehicles in the United States and is not available in Canada. Ensure you have all the key fobs you intend to program with you before starting, as this process will take approximately 30 minutes.
Step-by-Step Programming Instructions for Your 2012 Cadillac SRX Key Fob
Follow these detailed steps to successfully program your new 2012 Cadillac SRX key fob:
-
Initiate Key Fob Programming: Begin by inserting the vehicle key, found within your new transmitter, into the key lock cylinder on the exterior driver’s side door. Turn the key to the unlock position five times in rapid succession, within a 10-second window. After completing this step correctly, the Driver Information Center (DIC) located in your instrument cluster will display the message “REMOTE LEARN PENDING, PLEASE WAIT.” This indicates that your Cadillac SRX has entered the key fob programming mode.
-
First 10-Minute Wait Period: Allow the system to process for ten minutes. During this time, the DIC will continue to display “REMOTE LEARN PENDING, PLEASE WAIT.” Patience is key here; do not interrupt the process. After the ten-minute interval, the DIC message will change to “PRESS ENGINE START BUTTON TO LEARN.”
-
Press Ignition and Subsequent Wait Periods: As prompted by the DIC, press the ignition button. The DIC will revert to displaying “REMOTE LEARN PENDING, PLEASE WAIT,” signaling the start of another ten-minute waiting period. Repeat step 2 and step 3 two more times. This means you will undergo a total of three ten-minute waiting periods. It’s crucial to complete all three cycles to ensure successful programming. After the third cycle is complete, all previously programmed key fobs will be erased from the system’s memory. Any key fobs you wish to use with your 2012 Cadillac SRX moving forward must be programmed in the following steps. The DIC should then display “READY FOR REMOTE # 1”, indicating the system is prepared to learn your new key fob.
-
Place New Transmitter in the Transmitter Pocket: Locate the transmitter pocket within your 2012 Cadillac SRX. It’s situated inside the center console storage area, between the driver and front passenger seats. Open the storage compartment and lift up the storage tray to gain access to the transmitter pocket. Place your new key fob transmitter directly into this pocket.
-
Program the New Transmitter: With the new transmitter placed in the designated pocket, press the ignition button once again. When your Cadillac SRX successfully learns the new transmitter, the DIC display will update to indicate that it is ready to program the next transmitter, if you have additional key fobs to program.
-
Finalize Programming: Remove the newly programmed transmitter from the transmitter pocket. To confirm successful programming, press either the “lock” or “unlock” button on the new key fob. Your 2012 Cadillac SRX should respond accordingly, indicating that the key fob replacement and programming process is complete.
By following these steps, you can easily program a new key fob for your 2012 Cadillac SRX, saving time and money compared to dealership programming services. Ensure each step is followed precisely for a smooth and successful key fob replacement experience.
