Lost or need to replace your Pontiac G6 key fob? Instead of heading straight to a dealership and facing hefty programming fees, you can actually program a new key fob yourself right at home. This guide provides straightforward instructions to get your new key fob working with your Pontiac G6, saving you time and money.
Step-by-Step Guide to Program Your Pontiac G6 Key Fob
This process is designed for Pontiac G6 models and allows you to program your key fob without any special tools. You can program up to four key fobs for your vehicle. It’s important to note that initiating this programming sequence will erase all previously programmed key fobs, so you’ll need to program all of your key fobs (both old and new) during this session.
Before You Begin:
- Get in the Driver’s Seat (or Passenger Seat): While the instructions mention the driver’s seat, some users find it easier to perform these steps from the front passenger seat.
- Remove Key from Ignition: Ensure the ignition is empty.
- Close All Doors: Make sure all doors of your Pontiac G6 are fully closed.
- Locate the MALL PGM Fuse: You’ll need to access your fuse panel and remove the MALL PGM fuse. Refer to your Pontiac G6 owner’s manual for the exact location of the fuse panel and the MALL PGM fuse.
Programming Steps:
- Turn Ignition to ACC: After removing the MALL PGM fuse, turn the ignition key to the ACC (Accessory) position.
- Cycle Ignition ACC to OFF: Quickly turn the ignition from ACC to OFF and back to ACC again within one second.
- Open and Close Door: Open and then close any vehicle door.
- Listen for the Chime: You should hear a chime sound. This chime indicates that the remote control door lock receiver has entered programming mode. If you don’t hear a chime, repeat steps 1-3.
- Press and Hold LOCK and UNLOCK: On the key fob you want to program, press and hold both the LOCK and UNLOCK buttons simultaneously for approximately 14 seconds.
- Repeat for Additional Fobs: If you have more key fobs to program, repeat step 5 immediately for each additional fob.
- Remove Key and Reinstall Fuse: Take the key out of the ignition. Go back to your fuse panel and reinstall the MALL PGM fuse.
Verification:
Test each of your programmed key fobs to ensure they are working correctly. Try locking and unlocking the doors, and if your fob has other functions like remote start or trunk release, test those as well.
Troubleshooting:
- No Chime: If you don’t hear a chime after step 4, double-check that you have correctly followed steps 1-3 and that the MALL PGM fuse is indeed removed.
- Fob Not Programming: Ensure you are holding the LOCK and UNLOCK buttons for the full 14 seconds. Also, make sure the battery in your key fob is good.
- Still Having Issues?: If you continue to experience problems, it might be necessary to consult your Pontiac G6 owner’s manual or seek assistance from a qualified automotive locksmith or dealership.
By following these steps, you can often successfully program your Pontiac G6 key fob and regain convenient keyless entry to your vehicle without incurring unnecessary expenses.
