Replacing your Pontiac G6 key fob doesn’t have to break the bank. While dealerships and locksmiths offer key fob replacement services, complete with programming, you can actually perform the programming yourself at home, saving a significant amount of money. This guide will walk you through the steps to program a new key fob for your Pontiac G6, empowering you to take control of your car maintenance.
Step-by-Step Guide to Program Your Pontiac G6 Key Fob
This procedure allows you to program both new and existing key fobs to your Pontiac G6. It’s important to note that when you enter programming mode, all previously programmed key fobs are erased, so you’ll need to reprogram all of them at once. You can program up to four key fobs for your vehicle.
Here’s how to program your Pontiac G6 key fob without any special tools:
-
Get Comfortable in the Driver’s Seat: Sit in the driver’s seat of your Pontiac G6. Some users find it easier to perform these steps from the front passenger seat, so choose whichever is most comfortable for you.
-
Remove the Ignition Key: Ensure the ignition key is removed from the ignition lock cylinder.
-
Close All Doors: Make sure all doors of your Pontiac G6 are fully closed.
-
Locate and Remove the MALL PGM Fuse: Find the fuse panel in your Pontiac G6. Refer to your owner’s manual for the exact location of the fuse panel and the MALL PGM fuse. Remove the MALL PGM fuse from the fuse panel. This fuse is related to the vehicle’s remote control functions.
-
Turn Ignition to ACC Position: Insert your key into the ignition and turn it to the ACC (Accessory) position. Do not start the engine.
-
Cycle Ignition ACC to OFF: Turn the ignition lock cylinder OFF, and then quickly back to the ACC position within one second. This quick cycling is important for initiating the programming sequence.
-
Open and Close the Door: Open and then close any door on your Pontiac G6. This action signals the system to enter programming mode.
-
Listen for the Chime: You should hear a chime sound, indicating that the remote control door lock receiver has entered the programming/diagnostic mode. If you do not hear a chime, repeat steps 1 through 7 carefully.
-
Program the Transmitter (Key Fob): Press and hold both the LOCK and UNLOCK buttons on the key fob you wish to program simultaneously for approximately 14 seconds.
-
Confirmation Chimes: After about 7 seconds of holding the buttons, you might hear a chime confirming synchronization. After approximately 14 seconds, you should hear another chime confirming successful programming of that key fob.
-
Program Additional Transmitters (If Necessary): If you have additional key fobs to program, repeat step 9 for each additional key fob.
-
Remove Key and Reinstall Fuse: Remove the ignition key from the ignition lock cylinder. Reinstall the MALL PGM fuse back into its location in the fuse panel.
-
Test Your Key Fobs: Validate that all programmed key fobs are working correctly by testing the LOCK, UNLOCK, and any other buttons on the fobs.
By following these instructions, you can successfully program a new Pontiac G6 Key Fob Replacement yourself. This DIY approach saves you money and provides a convenient solution for key fob issues. Remember to always double-check your owner’s manual for any specific instructions related to your Pontiac G6 model year.
