Having a working key fob for your 1995 Jeep Grand Cherokee adds a layer of convenience to your daily driving. Instead of fumbling with keys in the door lock, a simple press of a button can unlock your doors. If you’ve purchased a new key fob or are experiencing issues with your current one, programming it yourself is a straightforward process for 1993-1995 ZJ models. This guide will walk you through the steps to program your 1995 Jeep Grand Cherokee Key Fob quickly and easily.
Confirming Keyless Entry System Compatibility
Before you begin programming, it’s essential to verify if your 1995 Jeep Grand Cherokee is equipped with a factory keyless entry system. The easiest way to check is by looking for a small black dome light located on the roof of your Jeep, usually near the rearview mirror or overhead console. This dome indicates the presence of the keyless entry receiver. If you do not see this dome, your ZJ was not originally equipped with keyless entry, and this programming procedure will not work. You would need to consider aftermarket keyless entry options instead. This guide is specifically for programming the original equipment key fobs for Jeeps that came with the factory system.
Step-by-Step Guide to Programming Your 1995 Jeep Grand Cherokee Key Fob
Once you’ve confirmed your Jeep has the factory keyless entry system, you can proceed with programming your new or existing 1995 Jeep Grand Cherokee key fob. Follow these simple steps:
- Ensure all doors, the rear liftgate, and the hood of your Jeep Grand Cherokee are completely closed. This is crucial for the system to enter programming mode.
- Get into the driver’s seat and close the driver’s side door.
- Insert your ignition key into the ignition cylinder, but do not turn the key to start the engine yet.
- Open the driver’s side door again.
- Manually slide the driver’s side door lock switch to the “Lock” position. The lock switch is usually located on the door panel and will move from the unlocked (often orange indicator) to the locked (often black indicator) position.
- Start your 1995 Jeep Grand Cherokee engine as you normally would.
- Take your keyless entry remote and point it towards the black dome light on the roof of your Jeep.
- Press and hold the ‘Unlock’ button on your key fob. This is typically the button on the left side of the remote. Continue holding the ‘Unlock’ button down until the red LED light on the key fob starts blinking rapidly. You should also hear the door locks cycle (lock and unlock) to confirm the system has recognized the new key fob.
- Turn off your Jeep Grand Cherokee engine and remove the key from the ignition within twenty (20) seconds of the door locks cycling.
- Test your newly programmed key fob to ensure it is working correctly. Press the ‘Lock’ and ‘Unlock’ buttons to verify the doors respond as expected.
Congratulations! You have successfully programmed your 1995 Jeep Grand Cherokee key fob. This straightforward procedure allows you to quickly get your remote working without the need for a dealership visit, saving you both time and money. Enjoy the convenience of keyless entry in your classic Jeep Grand Cherokee.
