Is your 2001 Gmc Yukon Key Fob malfunctioning, or have you acquired a new key fob that needs programming? Don’t worry, programming your key fob for a 2001 GMC Yukon can be a straightforward process you can accomplish right at home. This guide will provide you with clear, easy-to-follow instructions to get your key fob working seamlessly with your vehicle’s remote keyless entry system.
Before you begin, gather all the key fobs you intend to use with your 2001 GMC Yukon. It’s important to note that the programming procedure will erase all previously programmed remotes. Therefore, you must program both your existing and any new key fobs you wish to use during this session.
Here are the programming steps for your 2001 GMC Yukon key fob:
-
Ensure all doors of your GMC Yukon are fully closed. Insert your key into the ignition, but do not turn it on yet.
-
Locate the UNLOCK button on the driver’s side door panel. Press and HOLD this UNLOCK button down. Maintain pressure on the button and DO NOT RELEASE it until instructed in step 4.
-
While still holding the UNLOCK button, quickly cycle the ignition from the ON position to the OFF position twice. The “ON” position is the point just before you would engage the starter to turn on the engine. “OFF” is the position where you can remove your key from the ignition. Do this ON-OFF cycle two times rapidly.
-
Now, RELEASE the UNLOCK button that you have been holding down. Upon releasing the button, you should observe the door locks cycling – locking and then unlocking. This lock cycling is the signal that your 2001 GMC Yukon has successfully entered key fob programming mode.
Note: If the door locks cycle before you release the UNLOCK button, this indicates that the programming sequence has not been initiated correctly. If this happens, you will need to repeat the process from step one. If the locks continue to cycle prematurely, double-check that you are following each step precisely. If issues persist, there might be a malfunction within your vehicle’s keyless entry system.
-
Take the first key fob you want to program. Simultaneously press and hold down both the LOCK and UNLOCK buttons on the key fob. Keep both buttons pressed until the vehicle responds by cycling the door locks once again. When programming a new, unprogrammed key fob, this step may take up to 5 minutes. If you are reprogramming a key fob that was previously paired with the vehicle, the response time will usually be quicker. Repeat this step for each additional key fob, both new and existing, that you want to operate with your 2001 GMC Yukon.
-
Once you have programmed all desired key fobs, turn the ignition key to the ON position. This action will exit the key fob programming mode. Programming is now complete.
-
Thoroughly test all programmed key fobs to ensure they are working correctly with your 2001 GMC Yukon’s remote keyless entry system. Check that all buttons – lock, unlock, and any other functions your key fob may have – are functioning as expected.
By following these instructions, you should be able to successfully program your 2001 GMC Yukon key fob. Enjoy the convenience of your working remote!
