Lost or need to replace your 2005 Pontiac G6 key fob? Instead of heading straight to a dealership and paying hefty programming fees, you can actually program a new or existing key fob yourself. This guide provides simple, do-it-yourself instructions to get your key fob working with your 2005 Pontiac G6, saving you time and money.
Programming your key fob at home is a straightforward process that requires no special tools. By following these steps, you can quickly regain remote access to your vehicle’s features.
Step-by-Step Programming Instructions for Your 2005 Pontiac G6 Key Fob
Before you begin, ensure you have all the necessary key fobs you intend to program, as the process will erase all previously programmed fobs.
- Get into the Driver’s Seat: Sit in the driver’s seat of your 2005 Pontiac G6. While the original poster mentioned the passenger seat being easier, the standard procedure starts from the driver’s seat.
- Remove the Key from the Ignition: Take your key completely out of the ignition.
- Close All Doors: Make sure all doors of your Pontiac G6 are fully closed.
- Locate and Remove the MALL PGM Fuse: Find the fuse panel, typically located inside the vehicle, and remove the MALL PGM fuse. Consult your owner’s manual for the precise location of the fuse panel and the MALL PGM fuse.
- Turn Ignition to ACC Position: Insert your key into the ignition and turn it to the ACC (Accessory) position. Do not start the engine.
- Cycle Ignition ACC and OFF: Turn the ignition from the ACC position to the OFF position, and then back to ACC within one second. This needs to be a quick cycle.
- Open and Close Any Door: Open and then close any door on your Pontiac G6.
- Listen for the Chime: You should hear an audible chime. This chime indicates that your 2005 Pontiac G6’s remote control door lock receiver has entered programming mode. If you do not hear a chime, repeat steps 1 through 7.
- Program the Transmitter: Press and hold both the LOCK and UNLOCK buttons on the key fob you wish to program simultaneously for approximately 14 seconds.
- Repeat for Additional Transmitters: If you have more key fobs to program, repeat step 9 for each additional transmitter.
- Remove Key and Reinstall Fuse: Take the key out of the ignition. Locate the MALL PGM fuse you removed earlier and reinstall it back into its original location in the fuse panel.
- Test Your Key Fobs: Test each programmed key fob to ensure it is working correctly by pressing the LOCK and UNLOCK buttons to verify they control the door locks.
Important Programming Notes
- Erase Previous Programming: Be aware that initiating the programming mode will erase all previously programmed key fobs. You must program all desired key fobs (both old and new) during this single programming session.
- Program One Vehicle at a Time: If you are programming key fobs for multiple vehicles, program them one at a time to prevent accidentally programming a fob to the wrong vehicle.
- Chime Confirmation: Listen carefully for the chime as it confirms you have successfully entered programming mode and when synchronization and programming are successful.
By following these instructions, you can easily program your 2005 Pontiac G6 key fob and enjoy the convenience of remote access to your vehicle. This DIY method allows you to save money and avoid the inconvenience of dealership or locksmith programming services.
